<< Chapter < Page Chapter >> Page >
By the end of this section, you will be able to:
  • Explain the phenomenon of total internal reflection
  • Describe the workings and uses of optical fibers
  • Analyze the reason for the sparkle of diamonds

A good-quality mirror may reflect more than 90 % of the light that falls on it, absorbing the rest. But it would be useful to have a mirror that reflects all of the light that falls on it. Interestingly, we can produce total reflection using an aspect of refraction.

Consider what happens when a ray of light strikes the surface between two materials, as shown in [link] (a). Part of the light crosses the boundary and is refracted; the rest is reflected. If, as shown in the figure, the index of refraction for the second medium is less than for the first, the ray bends away from the perpendicular. (Since n 1 > n 2 , the angle of refraction is greater than the angle of incidence—that is, θ 1 > θ 2 . ) Now imagine what happens as the incident angle increases. This causes θ 2 to increase also. The largest the angle of refraction θ 2 can be is 90 ° , as shown in part (b). The critical angle     θ c for a combination of materials is defined to be the incident angle θ 1 that produces an angle of refraction of 90 ° . That is, θ c is the incident angle for which θ 2 = 90 ° . If the incident angle θ 1 is greater than the critical angle, as shown in [link] (c), then all of the light is reflected back into medium 1, a condition called total internal reflection    . (As the figure shows, the reflected rays obey the law of reflection so that the angle of reflection is equal to the angle of incidence in all three cases.)

In figure a, an incident ray at an angle theta 1 with a perpendicular line drawn at the point of incidence travels from n 1 to n 2. The incident ray undergoes both refraction and reflection. The angle of refraction o the refracted ray in medium n 2 is theta 2. The angle of reflection of the reflected ray in medium 1 is theta 1. In figure b, the incident angle is theta c which is larger than the angle of incidence in figure a. The  angle of refraction theta 2 becomes 90 degrees and the angle of reflection is theta c. In figure c, the angle of incidence theta 1 is greater than theta c, total internal reflection takes place and only reflection takes place. The light ray travels back into medium n 1, with the reflection angle being theta one.
(a) A ray of light crosses a boundary where the index of refraction decreases. That is, n 2 < n 1 . The ray bends away from the perpendicular. (b) The critical angle θ c is the angle of incidence for which the angle of refraction is 90 ° . (c) Total internal reflection occurs when the incident angle is greater than the critical angle.

Snell’s law states the relationship between angles and indices of refraction. It is given by

n 1 sin θ 1 = n 2 sin θ 2 .

When the incident angle equals the critical angle ( θ 1 = θ c ) , the angle of refraction is 90 ° ( θ 2 = 90 ° ) . Noting that sin 90 ° = 1 , Snell’s law in this case becomes

n 1 sin θ 1 = n 2 .

The critical angle θ c for a given combination of materials is thus

θ c = sin −1 ( n 2 n 1 ) for n 1 > n 2 .

Total internal reflection occurs for any incident angle greater than the critical angle θ c , and it can only occur when the second medium has an index of refraction less than the first. Note that this equation is written for a light ray that travels in medium 1 and reflects from medium 2, as shown in [link] .

Determining a critical angle

What is the critical angle for light traveling in a polystyrene (a type of plastic) pipe surrounded by air? The index of refraction for polystyrene is 1.49.

Strategy

The index of refraction of air can be taken to be 1.00, as before. Thus, the condition that the second medium (air) has an index of refraction less than the first (plastic) is satisfied, and we can use the equation

θ c = sin −1 ( n 2 n 1 )

to find the critical angle θ c , where n 2 = 1.00 and n 1 = 1.49 .

Solution

Substituting the identified values gives

θ c = sin −1 ( 1.00 1.49 ) = sin −1 ( 0.671 ) = 42.2 ° .

Significance

This result means that any ray of light inside the plastic that strikes the surface at an angle greater than 42.2 ° is totally reflected. This makes the inside surface of the clear plastic a perfect mirror for such rays, without any need for the silvering used on common mirrors. Different combinations of materials have different critical angles, but any combination with n 1 > n 2 can produce total internal reflection. The same calculation as made here shows that the critical angle for a ray going from water to air is 48.6 ° , whereas that from diamond to air is 24.4 ° , and that from flint glass to crown glass is 66.3 ° .

Got questions? Get instant answers now!

Questions & Answers

Ayele, K., 2003. Introductory Economics, 3rd ed., Addis Ababa.
Widad Reply
can you send the book attached ?
Ariel
?
Ariel
What is economics
Widad Reply
the study of how humans make choices under conditions of scarcity
AI-Robot
U(x,y) = (x×y)1/2 find mu of x for y
Desalegn Reply
U(x,y) = (x×y)1/2 find mu of x for y
Desalegn
what is ecnomics
Jan Reply
this is the study of how the society manages it's scarce resources
Belonwu
what is macroeconomic
John Reply
macroeconomic is the branch of economics which studies actions, scale, activities and behaviour of the aggregate economy as a whole.
husaini
etc
husaini
difference between firm and industry
husaini Reply
what's the difference between a firm and an industry
Abdul
firm is the unit which transform inputs to output where as industry contain combination of firms with similar production 😅😅
Abdulraufu
Suppose the demand function that a firm faces shifted from Qd  120 3P to Qd  90  3P and the supply function has shifted from QS  20  2P to QS 10  2P . a) Find the effect of this change on price and quantity. b) Which of the changes in demand and supply is higher?
Toofiq Reply
explain standard reason why economic is a science
innocent Reply
factors influencing supply
Petrus Reply
what is economic.
Milan Reply
scares means__________________ends resources. unlimited
Jan
economics is a science that studies human behaviour as a relationship b/w ends and scares means which have alternative uses
Jan
calculate the profit maximizing for demand and supply
Zarshad Reply
Why qualify 28 supplies
Milan
what are explicit costs
Nomsa Reply
out-of-pocket costs for a firm, for example, payments for wages and salaries, rent, or materials
AI-Robot
concepts of supply in microeconomics
David Reply
economic overview notes
Amahle Reply
identify a demand and a supply curve
Salome Reply
i don't know
Parul
there's a difference
Aryan
Demand curve shows that how supply and others conditions affect on demand of a particular thing and what percent demand increase whith increase of supply of goods
Israr
Hi Sir please how do u calculate Cross elastic demand and income elastic demand?
Abari
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 3

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, University physics volume 3. OpenStax CNX. Nov 04, 2016 Download for free at http://cnx.org/content/col12067/1.4
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'University physics volume 3' conversation and receive update notifications?

Ask