<< Chapter < Page Chapter >> Page >

Problem-solving strategy for rotational dynamics

  1. Examine the situation to determine that torque and mass are involved in the rotation . Draw a careful sketch of the situation.
  2. Determine the system of interest .
  3. Draw a free body diagram . That is, draw and label all external forces acting on the system of interest.
  4. Apply net τ = α = net τ I size 12{τ=Iα,```α= { { ital "net"τ} over {I} } } {} , the rotational equivalent of Newton’s second law, to solve the problem . Care must be taken to use the correct moment of inertia and to consider the torque about the point of rotation.
  5. As always, check the solution to see if it is reasonable .

Making connections

In statics, the net torque is zero, and there is no angular acceleration. In rotational motion, net torque is the cause of angular acceleration, exactly as in Newton’s second law of motion for rotation.

Illustrations of ten different objects accompanied by their rotational inertias.
Some rotational inertias.

Calculating the effect of mass distribution on a merry-go-round

Consider the father pushing a playground merry-go-round in [link] . He exerts a force of 250 N at the edge of the 50.0-kg merry-go-round, which has a 1.50 m radius. Calculate the angular acceleration produced (a) when no one is on the merry-go-round and (b) when an 18.0-kg child sits 1.25 m away from the center. Consider the merry-go-round itself to be a uniform disk with negligible retarding friction.

The given figure shows a man pushing a merry-go-round by a force F, indicated by a red arrow which is perpendicular to the radius r, of the merry-go-round, such that it moves in counter-clockwise direction.
A father pushes a playground merry-go-round at its edge and perpendicular to its radius to achieve maximum torque.

Strategy

Angular acceleration is given directly by the expression α = net τ I size 12{τ=Iα,`α= { { ital "net"τ} over {I} } } {} :

α = τ I . size 12{α= { {τ} over {I} } } {}

To solve for α size 12{α} {} , we must first calculate the torque τ size 12{τ} {} (which is the same in both cases) and moment of inertia I size 12{I} {} (which is greater in the second case). To find the torque, we note that the applied force is perpendicular to the radius and friction is negligible, so that

τ = rF sin θ = ( 1.50 m ) ( 250 N ) = 375 N m. size 12{τ="rFsinθ"= \( 1 "." "50m" \) \( "250N" \) ="375N" "." "m."} {}

Solution for (a)

The moment of inertia of a solid disk about this axis is given in [link] to be

1 2 MR 2 , size 12{ { {1} over {2} } ital "MR" rSup { size 8{2} } ","} {}

where M = 50.0 kg size 12{M="50" "." 0 ital "kg"} {} and R = 1.50 m size 12{R=1 "." "50"m} {} , so that

I = (0 . 500) ( 50.0 kg ) ( 1.50 m ) 2 = 56.25 kg m 2 . size 12{I=0 "." 5 \( "50" "." "0kg" \) \( 1 "." "50m" \) rSup { size 8{2} } ="56" "." "25kg" "." "m" rSup { size 8{2} } "."} {}

Now, after we substitute the known values, we find the angular acceleration to be

α = τ I = 375 N m 56.25 kg m 2 = 6.67 rad s 2 . size 12{α= { {τ} over {I} } = { {"375"`"N" "." "m"} over {"56" "." "25"`"kg" "." "m" rSup { size 8{2} } } } =6 "." "67"` { {"rad"} over {s rSup { size 8{2} } } } "."} {}

Solution for (b)

We expect the angular acceleration for the system to be less in this part, because the moment of inertia is greater when the child is on the merry-go-round. To find the total moment of inertia I size 12{I} {} , we first find the child’s moment of inertia I c size 12{I rSub { size 8{c} } } {} by considering the child to be equivalent to a point mass at a distance of 1.25 m from the axis. Then,

I c = MR 2 = ( 18.0 kg ) ( 1.25 m ) 2 = 28.13 kg m 2 . size 12{I rSub { size 8{c} } ="MR" rSup { size 8{2} } = \( "18" "." 0`"kg" \) \( 1 "." "25"`m \) rSup { size 8{2} } ="28" "." "13"`"kg" "." m rSup { size 8{2} } "."} {}

The total moment of inertia is the sum of moments of inertia of the merry-go-round and the child (about the same axis). To justify this sum to yourself, examine the definition of I size 12{I} {} :

I = 28.13 kg m 2 + 56.25 kg m 2 = 84.38 kg m 2 . size 12{I="28" "." "13"`"kg" "." m rSup { size 8{2} } +"56" "." "25"`"kg" "." m rSup { size 8{2} } ="84" "." "38"`"kg" "." m rSup { size 8{2} } } {}

Substituting known values into the equation for α size 12{α} {} gives

α = τ I = 375 N m 84.38 kg m 2 = 4.44 rad s 2 . size 12{α= { {τ} over {I} } = { {"375N" "." m} over {"84" "." "38kg" "." m rSup { size 8{2} } } } =4 "." "44" { {"rad"} over {s rSup { size 8{2} } } } "."} {}

Discussion

The angular acceleration is less when the child is on the merry-go-round than when the merry-go-round is empty, as expected. The angular accelerations found are quite large, partly due to the fact that friction was considered to be negligible. If, for example, the father kept pushing perpendicularly for 2.00 s, he would give the merry-go-round an angular velocity of 13.3 rad/s when it is empty but only 8.89 rad/s when the child is on it. In terms of revolutions per second, these angular velocities are 2.12 rev/s and 1.41 rev/s, respectively. The father would end up running at about 50 km/h in the first case. Summer Olympics, here he comes! Confirmation of these numbers is left as an exercise for the reader.

Questions & Answers

if three forces F1.f2 .f3 act at a point on a Cartesian plane in the daigram .....so if the question says write down the x and y components ..... I really don't understand
Syamthanda Reply
hey , can you please explain oxidation reaction & redox ?
Boitumelo Reply
hey , can you please explain oxidation reaction and redox ?
Boitumelo
for grade 12 or grade 11?
Sibulele
the value of V1 and V2
Tumelo Reply
advantages of electrons in a circuit
Rethabile Reply
we're do you find electromagnetism past papers
Ntombifuthi
what a normal force
Tholulwazi Reply
it is the force or component of the force that the surface exert on an object incontact with it and which acts perpendicular to the surface
Sihle
what is physics?
Petrus Reply
what is the half reaction of Potassium and chlorine
Anna Reply
how to calculate coefficient of static friction
Lisa Reply
how to calculate static friction
Lisa
How to calculate a current
Tumelo
how to calculate the magnitude of horizontal component of the applied force
Mogano
How to calculate force
Monambi
a structure of a thermocouple used to measure inner temperature
Anna Reply
a fixed gas of a mass is held at standard pressure temperature of 15 degrees Celsius .Calculate the temperature of the gas in Celsius if the pressure is changed to 2×10 to the power 4
Amahle Reply
How is energy being used in bonding?
Raymond Reply
what is acceleration
Syamthanda Reply
a rate of change in velocity of an object whith respect to time
Khuthadzo
how can we find the moment of torque of a circular object
Kidist
Acceleration is a rate of change in velocity.
Justice
t =r×f
Khuthadzo
how to calculate tension by substitution
Precious Reply
hi
Shongi
hi
Leago
use fnet method. how many obects are being calculated ?
Khuthadzo
khuthadzo hii
Hulisani
how to calculate acceleration and tension force
Lungile Reply
you use Fnet equals ma , newtoms second law formula
Masego
please help me with vectors in two dimensions
Mulaudzi Reply
how to calculate normal force
Mulaudzi
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 3

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, College physics. OpenStax CNX. Jul 27, 2015 Download for free at http://legacy.cnx.org/content/col11406/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'College physics' conversation and receive update notifications?

Ask