<< Chapter < Page Chapter >> Page >

Problem-solving strategy for rotational dynamics

  1. Examine the situation to determine that torque and mass are involved in the rotation . Draw a careful sketch of the situation.
  2. Determine the system of interest .
  3. Draw a free body diagram . That is, draw and label all external forces acting on the system of interest.
  4. Apply net τ = α = net τ I size 12{τ=Iα,```α= { { ital "net"τ} over {I} } } {} , the rotational equivalent of Newton’s second law, to solve the problem . Care must be taken to use the correct moment of inertia and to consider the torque about the point of rotation.
  5. As always, check the solution to see if it is reasonable .

Making connections

In statics, the net torque is zero, and there is no angular acceleration. In rotational motion, net torque is the cause of angular acceleration, exactly as in Newton’s second law of motion for rotation.

Illustrations of ten different objects accompanied by their rotational inertias.
Some rotational inertias.

Calculating the effect of mass distribution on a merry-go-round

Consider the father pushing a playground merry-go-round in [link] . He exerts a force of 250 N at the edge of the 50.0-kg merry-go-round, which has a 1.50 m radius. Calculate the angular acceleration produced (a) when no one is on the merry-go-round and (b) when an 18.0-kg child sits 1.25 m away from the center. Consider the merry-go-round itself to be a uniform disk with negligible retarding friction.

The given figure shows a man pushing a merry-go-round by a force F, indicated by a red arrow which is perpendicular to the radius r, of the merry-go-round, such that it moves in counter-clockwise direction.
A father pushes a playground merry-go-round at its edge and perpendicular to its radius to achieve maximum torque.

Strategy

Angular acceleration is given directly by the expression α = net τ I size 12{τ=Iα,`α= { { ital "net"τ} over {I} } } {} :

α = τ I . size 12{α= { {τ} over {I} } } {}

To solve for α size 12{α} {} , we must first calculate the torque τ size 12{τ} {} (which is the same in both cases) and moment of inertia I size 12{I} {} (which is greater in the second case). To find the torque, we note that the applied force is perpendicular to the radius and friction is negligible, so that

τ = rF sin θ = ( 1.50 m ) ( 250 N ) = 375 N m. size 12{τ="rFsinθ"= \( 1 "." "50m" \) \( "250N" \) ="375N" "." "m."} {}

Solution for (a)

The moment of inertia of a solid disk about this axis is given in [link] to be

1 2 MR 2 , size 12{ { {1} over {2} } ital "MR" rSup { size 8{2} } ","} {}

where M = 50.0 kg size 12{M="50" "." 0 ital "kg"} {} and R = 1.50 m size 12{R=1 "." "50"m} {} , so that

I = (0 . 500) ( 50.0 kg ) ( 1.50 m ) 2 = 56.25 kg m 2 . size 12{I=0 "." 5 \( "50" "." "0kg" \) \( 1 "." "50m" \) rSup { size 8{2} } ="56" "." "25kg" "." "m" rSup { size 8{2} } "."} {}

Now, after we substitute the known values, we find the angular acceleration to be

α = τ I = 375 N m 56.25 kg m 2 = 6.67 rad s 2 . size 12{α= { {τ} over {I} } = { {"375"`"N" "." "m"} over {"56" "." "25"`"kg" "." "m" rSup { size 8{2} } } } =6 "." "67"` { {"rad"} over {s rSup { size 8{2} } } } "."} {}

Solution for (b)

We expect the angular acceleration for the system to be less in this part, because the moment of inertia is greater when the child is on the merry-go-round. To find the total moment of inertia I size 12{I} {} , we first find the child’s moment of inertia I c size 12{I rSub { size 8{c} } } {} by considering the child to be equivalent to a point mass at a distance of 1.25 m from the axis. Then,

I c = MR 2 = ( 18.0 kg ) ( 1.25 m ) 2 = 28.13 kg m 2 . size 12{I rSub { size 8{c} } ="MR" rSup { size 8{2} } = \( "18" "." 0`"kg" \) \( 1 "." "25"`m \) rSup { size 8{2} } ="28" "." "13"`"kg" "." m rSup { size 8{2} } "."} {}

The total moment of inertia is the sum of moments of inertia of the merry-go-round and the child (about the same axis). To justify this sum to yourself, examine the definition of I size 12{I} {} :

I = 28.13 kg m 2 + 56.25 kg m 2 = 84.38 kg m 2 . size 12{I="28" "." "13"`"kg" "." m rSup { size 8{2} } +"56" "." "25"`"kg" "." m rSup { size 8{2} } ="84" "." "38"`"kg" "." m rSup { size 8{2} } } {}

Substituting known values into the equation for α size 12{α} {} gives

α = τ I = 375 N m 84.38 kg m 2 = 4.44 rad s 2 . size 12{α= { {τ} over {I} } = { {"375N" "." m} over {"84" "." "38kg" "." m rSup { size 8{2} } } } =4 "." "44" { {"rad"} over {s rSup { size 8{2} } } } "."} {}

Discussion

The angular acceleration is less when the child is on the merry-go-round than when the merry-go-round is empty, as expected. The angular accelerations found are quite large, partly due to the fact that friction was considered to be negligible. If, for example, the father kept pushing perpendicularly for 2.00 s, he would give the merry-go-round an angular velocity of 13.3 rad/s when it is empty but only 8.89 rad/s when the child is on it. In terms of revolutions per second, these angular velocities are 2.12 rev/s and 1.41 rev/s, respectively. The father would end up running at about 50 km/h in the first case. Summer Olympics, here he comes! Confirmation of these numbers is left as an exercise for the reader.

Questions & Answers

Ayele, K., 2003. Introductory Economics, 3rd ed., Addis Ababa.
Widad Reply
can you send the book attached ?
Ariel
?
Ariel
What is economics
Widad Reply
the study of how humans make choices under conditions of scarcity
AI-Robot
U(x,y) = (x×y)1/2 find mu of x for y
Desalegn Reply
U(x,y) = (x×y)1/2 find mu of x for y
Desalegn
what is ecnomics
Jan Reply
this is the study of how the society manages it's scarce resources
Belonwu
what is macroeconomic
John Reply
macroeconomic is the branch of economics which studies actions, scale, activities and behaviour of the aggregate economy as a whole.
husaini
etc
husaini
difference between firm and industry
husaini Reply
what's the difference between a firm and an industry
Abdul
firm is the unit which transform inputs to output where as industry contain combination of firms with similar production 😅😅
Abdulraufu
Suppose the demand function that a firm faces shifted from Qd  120 3P to Qd  90  3P and the supply function has shifted from QS  20  2P to QS 10  2P . a) Find the effect of this change on price and quantity. b) Which of the changes in demand and supply is higher?
Toofiq Reply
explain standard reason why economic is a science
innocent Reply
factors influencing supply
Petrus Reply
what is economic.
Milan Reply
scares means__________________ends resources. unlimited
Jan
economics is a science that studies human behaviour as a relationship b/w ends and scares means which have alternative uses
Jan
calculate the profit maximizing for demand and supply
Zarshad Reply
Why qualify 28 supplies
Milan
what are explicit costs
Nomsa Reply
out-of-pocket costs for a firm, for example, payments for wages and salaries, rent, or materials
AI-Robot
concepts of supply in microeconomics
David Reply
economic overview notes
Amahle Reply
identify a demand and a supply curve
Salome Reply
i don't know
Parul
there's a difference
Aryan
Demand curve shows that how supply and others conditions affect on demand of a particular thing and what percent demand increase whith increase of supply of goods
Israr
Hi Sir please how do u calculate Cross elastic demand and income elastic demand?
Abari
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 3

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, College physics. OpenStax CNX. Jul 27, 2015 Download for free at http://legacy.cnx.org/content/col11406/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'College physics' conversation and receive update notifications?

Ask