<< Chapter < Page Chapter >> Page >
This chapter discusses measuring descriptive statistical information using the center of the data

The "center" of a data set is also a way of describing location. The two most widely used measures of the "center" of the data are the mean (average) and the median . To calculate the mean weight of 50 people, add the 50 weights together and divide by 50. To find the median weight of the 50 people, order the data and find the number that splits the data into two equal parts (previously discussed under box plots in this chapter). The median is generally a better measure of the center when there are extreme values or outliers because it is not affected by the precise numerical values of the outliers. The mean is the most common measure of the center.

The words "mean" and "average" are often used interchangeably. The substitution of one word for the other is common practice. The technical term is "arithmetic mean" and "average" is technically a center location. However, in practice among non-statisticians, "average" is commonly accepted for "arithmetic mean."

The mean can also be calculated by multiplying each distinct value by its frequency and then dividing the sum by the total number of data values. The letter used to represent the sample mean is an x with a bar over it (pronounced " x bar"): x .

The Greek letter μ (pronounced "mew") represents the population mean. One of the requirements for the sample mean to be a good estimate of the population mean is for the sample taken to be truly random.

To see that both ways of calculating the mean are the same, consider the sample:

  • 1
  • 1
  • 1
  • 2
  • 2
  • 3
  • 4
  • 4
  • 4
  • 4
  • 4

x ¯ = 1 + 1 + 1 + 2 + 2 + 3 + 4 + 4 + 4 + 4 + 4 11 = 2.7
x ¯ = 3 × 1 + 2 × 2 + 1 × 3 + 5 × 4 11 = 2.7

In the second calculation for the sample mean, the frequencies are 3, 2, 1, and 5.

You can quickly find the location of the median by using the expression n + 1 2 .

The letter n is the total number of data values in the sample. If n is an odd number, the median is the middle value of the ordered data (ordered smallest to largest). If n is an even number, the median is equal to the two middle values added together and divided by 2 after the data has been ordered. For example, if the total number of data values is 97, then n + 1 2 = 97 + 1 2 = 49 . The median is the 49th value in the ordered data. If the total number of data values is 100, then n + 1 2 = 100 + 1 2 = 50.5 . The median occurs midway between the 50th and 51st values. The location of the median and the value of the median are not the same. The upper case letter M is often used to represent the median. The next example illustrates the location of the median and the value of the median.

AIDS data indicating the number of months an AIDS patient lives after taking a new antibody drug are as follows (smallest to largest):

  • 3
  • 4
  • 8
  • 8
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 15
  • 16
  • 16
  • 17
  • 17
  • 18
  • 21
  • 22
  • 22
  • 24
  • 24
  • 25
  • 26
  • 26
  • 27
  • 27
  • 29
  • 29
  • 31
  • 32
  • 33
  • 33
  • 34
  • 34
  • 35
  • 37
  • 40
  • 44
  • 44
  • 47

Calculate the mean and the median.

The calculation for the mean is:

x ¯ = [ 3 + 4 + ( 8 ) ( 2 ) + 10 + 11 + 12 + 13 + 14 + ( 15 ) ( 2 ) + ( 16 ) ( 2 ) + ... + 35 + 37 + 40 + ( 44 ) ( 2 ) + 47 ] 40 = 23.6

To find the median, M , first use the formula for the location. The location is:

n + 1 2 = 40 + 1 2 = 20.5

Starting at the smallest value, the median is located between the 20th and 21st values (the two 24s):

  • 3
  • 4
  • 8
  • 8
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 15
  • 16
  • 16
  • 17
  • 17
  • 18
  • 21
  • 22
  • 22
  • 24
  • 24
  • 25
  • 26
  • 26
  • 27
  • 27
  • 29
  • 29
  • 31
  • 32
  • 33
  • 33
  • 34
  • 34
  • 35
  • 37
  • 40
  • 44
  • 44
  • 47

M = 24 + 24 2 = 24

The median is 24.

Using the ti-83,83+,84, 84+ calculators

Calculator Instructions are located in the menu item 14:Appendix (Notes for the TI-83, 83+, 84, 84+ Calculators).
  • Enter data into the list editor. Press STAT 1:EDIT
  • Put the data values in list L1.
  • Press STAT and arrow to CALC. Press 1:1-VarStats. Press 2nd 1 for L1 and ENTER.
  • Press the down and up arrow keys to scroll.
x ¯ = 23.6 , M = 24

Suppose that, in a small town of 50 people, one person earns $5,000,000 per year and the other 49 each earn $30,000. Which is the better measure of the "center," the mean or the median?

x ¯ = 5000000 + 49 × 30000 50 = 129400

M = 30000

(There are 49 people who earn $30,000 and one person who earns $5,000,000.)

The median is a better measure of the "center" than the mean because 49 of the values are 30,000 and one is 5,000,000. The 5,000,000 is an outlier. The 30,000 gives us a better sense of the middle of the data.

Another measure of the center is the mode. The mode is the most frequent value. If a data set has two values that occur the same number of times, then the set is bimodal.

Statistics exam scores for 20 students are as follows

Statistics exam scores for 20 students are as follows:

  • 50
  • 53
  • 59
  • 59
  • 63
  • 63
  • 72
  • 72
  • 72
  • 72
  • 72
  • 76
  • 78
  • 81
  • 83
  • 84
  • 84
  • 84
  • 90
  • 93

Find the mode.

The most frequent score is 72, which occurs five times. Mode = 72.

Five real estate exam scores are 430, 430, 480, 480, 495. The data set is bimodal because the scores 430 and 480 each occur twice.

When is the mode the best measure of the "center"? Consider a weight loss program that advertises a mean weight loss of six pounds the first week of the program. The mode might indicate that most people lose two pounds the first week, making the program less appealing.

The mode can be calculated for qualitative data as well as for quantitative data.

Statistical software will easily calculate the mean, the median, and the mode. Some graphing calculators can also make these calculations. In the real world, people make these calculations using software.

The law of large numbers and the mean

The Law of Large Numbers says that if you take samples of larger and larger size from any population, then the mean x ¯ of the sample is very likely to get closer and closer to µ . This is discussed in more detail in The Central Limit Theorem .

The formula for the mean is located in the Summary of Formulas section course.

Sampling distributions and statistic of a sampling distribution

You can think of a sampling distribution as a relative frequency distribution with a great many samples. (See Sampling and Data for a review of relative frequency). Suppose thirty randomly selected students were asked the number of movies they watched the previous week. The results are in the relative frequency table shown below.

# of movies Relative Frequency
0 5/30
1 15/30
2 6/30
3 4/30
4 1/30

If you let the number of samples get very large (say, 300 million or more), the relative frequency table becomes a relative frequency distribution .

A statistic is a number calculated from a sample. Statistic examples include the mean, the median and the mode as well as others. The sample mean x ¯ is an example of a statistic which estimates the population mean μ .

Questions & Answers

it is the relatively stable flow of income
Chidubem Reply
what is circular flow of income
Divine Reply
branches of macroeconomics
SHEDRACK Reply
what is Flexible exchang rate?
poudel Reply
is gdp a reliable measurement of wealth
Atega Reply
introduction to econometrics
Husseini Reply
Hi
mostafa
hi
LEMLEM
hello
Sammol
hi
Mahesh
bi
Ruqayat
hi
Ruqayat
Hi fellas
Nyawa
hey
Sammol
hi
God
hello
Jahara
Good morning
Jorge
hi
abubakar
hi
Nmesoma
hi
Mahesh
Hi
Tom
Why is unemployment rate never zero at full employment?
Priyanka Reply
bcoz of existence of frictional unemployment in our economy.
Umashankar
what is flexible exchang rate?
poudel
due to existence of the pple with disabilities
Abdulraufu
the demand of a good rises, causing the demand for another good to fall
Rushawn Reply
is it possible to leave every good at the same level
Joseph
I don't think so. because check it, if the demand for chicken increases, people will no longer consume fish like they used to causing a fall in the demand for fish
Anuolu
is not really possible to let the value of a goods to be same at the same time.....
Salome
Suppose the inflation rate is 6%, does it mean that all the goods you purchase will cost 6% more than previous year? Provide with reasoning.
Geetha Reply
Not necessarily. To measure the inflation rate economists normally use an averaged price index of a basket of certain goods. So if you purchase goods included in the basket, you will notice that you pay 6% more, otherwise not necessarily.
Waeth
discus major problems of macroeconomics
Alii Reply
what is the problem of macroeconomics
Yoal
Economic growth Stable prices and low unemployment
Ephraim
explain inflationcause and itis degre
Miresa Reply
what is inflation
Getu
increase in general price levels
WEETO
Good day How do I calculate this question: C= 100+5yd G= 2000 T= 2000 I(planned)=200. Suppose the actual output is 3000. What is the level of planned expenditures at this level of output?
Chisomo Reply
how to calculate actual output?
Chisomo
how to calculate the equilibrium income
Beshir
Criteria for determining money supply
Thapase Reply
who we can define macroeconomics in one line
Muhammad
Aggregate demand
Mohammed
C=k100 +9y and i=k50.calculate the equilibrium level of output
Mercy Reply
Hi
Isiaka
Hi
Geli
hy
Man
👋
Bahunda
hy how are you?
Man
ys
Amisha
how are you guys
Sekou
f9 guys
Amisha
how are you guys
Sekou
ys am also fine
Amisha
fine and you guys
Geli
from Nepal
Amisha
nawalparasi district from belatari
Amisha
nd u
Amisha
I am Camara from Guinea west Africa... happy to meet you guys here
Sekou
ma management ho
Amisha
ahile becheclor ho
Amisha
hjr ktm bta ho ani k kaam grnu hunxa tw
Amisha
belatari
Amisha
1st year ho
Amisha
nd u
Amisha
ahh
Amisha
kaha biratnagar
Amisha
ys
Amisha
kina k vo
Amisha
money as unit of account means what?
Kalombe
A unit of account is something that can be used to value goods and services and make calculations
Jim
all of you please speak in English I can't understand you're language
Muhammad
I want to know how can we define macroeconomics in one line
Muhammad
it must be .9 or 0.9 no Mpc is greater than 1 Y=100+.9Y+50 Y-.9Y=150 0.1Y/0.1=150/0.1 Y=1500
Kalombe
Mercy is it clear?😋
Kalombe
hi can someone help me on this question If a negative shocks shifts the IS curve to the left, what type of policy do you suggest so as to stabilize the level of output? discuss your answer using appropriate graph.
Galge Reply
if interest rate is increased this will will reduce the level of income shifting the curve to the left ◀️
Kalombe
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 3

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Collaborative statistics-parzen remix. OpenStax CNX. Jul 15, 2009 Download for free at http://legacy.cnx.org/content/col10732/1.2
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Collaborative statistics-parzen remix' conversation and receive update notifications?

Ask