<< Chapter < Page Chapter >> Page >

Intensity of the fringes

[link] shows that the intensity of the fringe for m = 3 is zero, but what about the other fringes? Calculate the intensity for the fringe at m = 1 relative to I 0 , the intensity of the central peak.

Strategy

Determine the angle for the double-slit interference fringe, using the equation from Interference , then determine the relative intensity in that direction due to diffraction by using [link] .

Solution

From the chapter on interference, we know that the bright interference fringes occur at d sin θ = m λ , or

sin θ = m λ d .

From [link] ,

I = I 0 ( sin β β ) 2 , where β = ϕ 2 = π D sin θ λ .

Substituting from above,

β = π D sin θ λ = π D λ · m λ d = m π D d .

For D = 2 λ , d = 6 λ , and m = 1 ,

β = ( 1 ) π ( 2 λ ) ( 6 λ ) = π 3 .

Then, the intensity is

I = I 0 ( sin β β ) 2 = I 0 ( sin ( π / 3 ) π / 3 ) 2 = 0.684 I 0 .

Significance

Note that this approach is relatively straightforward and gives a result that is almost exactly the same as the more complicated analysis using phasors to work out the intensity values of the double-slit interference (thin line in [link] ). The phasor approach accounts for the downward slope in the diffraction intensity (blue line) so that the peak near m = 1 occurs at a value of θ ever so slightly smaller than we have shown here.

Got questions? Get instant answers now!

Two-slit diffraction

Suppose that in Young’s experiment, slits of width 0.020 mm are separated by 0.20 mm. If the slits are illuminated by monochromatic light of wavelength 500 nm, how many bright fringes are observed in the central peak of the diffraction pattern?

Solution

From [link] , the angular position of the first diffraction minimum is θ sin θ = λ D = 5.0 × 10 −7 m 2.0 × 10 −5 m = 2.5 × 10 −2 rad .

Using sin θ = m λ for θ = 2.5 × 10 −2 rad , we find

m = d sin θ λ = ( 0.20 mm ) ( 2.5 × 10 −2 rad ) ( 5.0 × 10 −7 m ) = 10 ,

which is the maximum interference order that fits inside the central peak. We note that m = ± 10 are missing orders as θ matches exactly. Accordingly, we observe bright fringes for

m = −9 , −8 , −7 , −6 , −5 , −4 , −3 , −2 , −1 , 0 , + 1 , + 2 , + 3 , + 4 , + 5 , + 6 , + 7 , + 8 , and + 9

for a total of 19 bright fringes.

Got questions? Get instant answers now!

Check Your Understanding For the experiment in [link] , show that m = 20 is also a missing order.

From d sin θ = m λ , the interference maximum occurs at 2.87 ° for m = 20 . From [link] , this is also the angle for the second diffraction minimum. ( Note: Both equations use the index m but they refer to separate phenomena.)

Got questions? Get instant answers now!

Explore the effects of double-slit diffraction. In this simulation written by Fu-Kwun Hwang, select N = 2 using the slider and see what happens when you control the slit width, slit separation and the wavelength. Can you make an order go “missing?”

Summary

  • With real slits with finite widths, the effects of interference and diffraction operate simultaneously to form a complicated intensity pattern.
  • Relative intensities of interference fringes within a diffraction pattern can be determined.
  • Missing orders occur when an interference maximum and a diffraction minimum are located together.

Conceptual questions

Shown below is the central part of the interference pattern for a pure wavelength of red light projected onto a double slit. The pattern is actually a combination of single- and double-slit interference. Note that the bright spots are evenly spaced. Is this a double- or single-slit characteristic? Note that some of the bright spots are dim on either side of the center. Is this a single- or double-slit characteristic? Which is smaller, the slit width or the separation between slits? Explain your responses.

Figure is an image showing red interference pattern on a black background. The central part has brighter lines. The lines are cut off at the top and bottom, seemingly enclosed between two sinusoidal waves of opposite phase.
Got questions? Get instant answers now!

Problems

Two slits of width 2 μ m, each in an opaque material, are separated by a center-to-center distance of 6 μ m . A monochromatic light of wavelength 450 nm is incident on the double-slit. One finds a combined interference and diffraction pattern on the screen.

(a) How many peaks of the interference will be observed in the central maximum of the diffraction pattern?

(b) How many peaks of the interference will be observed if the slit width is doubled while keeping the distance between the slits same?

(c) How many peaks of interference will be observed if the slits are separated by twice the distance, that is, 12 μ m, while keeping the widths of the slits same?

(d) What will happen in (a) if instead of 450-nm light another light of wavelength 680 nm is used?

(e) What is the value of the ratio of the intensity of the central peak to the intensity of the next bright peak in (a)?

(f) Does this ratio depend on the wavelength of the light?

(g) Does this ratio depend on the width or separation of the slits?

Got questions? Get instant answers now!

A double slit produces a diffraction pattern that is a combination of single- and double-slit interference. Find the ratio of the width of the slits to the separation between them, if the first minimum of the single-slit pattern falls on the fifth maximum of the double-slit pattern. (This will greatly reduce the intensity of the fifth maximum.)

0.200

Got questions? Get instant answers now!

For a double-slit configuration where the slit separation is four times the slit width, how many interference fringes lie in the central peak of the diffraction pattern?

Got questions? Get instant answers now!

Light of wavelength 500 nm falls normally on 50 slits that are 2.5 × 10 −3 mm wide and spaced 5.0 × 10 −3 mm apart. How many interference fringes lie in the central peak of the diffraction pattern?

3

Got questions? Get instant answers now!

A monochromatic light of wavelength 589 nm incident on a double slit with slit width 2.5 μ m and unknown separation results in a diffraction pattern containing nine interference peaks inside the central maximum. Find the separation of the slits.

Got questions? Get instant answers now!

When a monochromatic light of wavelength 430 nm incident on a double slit of slit separation 5 μ m , there are 11 interference fringes in its central maximum. How many interference fringes will be in the central maximum of a light of wavelength 632.8 nm for the same double slit?

9

Got questions? Get instant answers now!

Determine the intensities of two interference peaks other than the central peak in the central maximum of the diffraction, if possible, when a light of wavelength 628 nm is incident on a double slit of width 500 nm and separation 1500 nm. Use the intensity of the central spot to be 1 mW/cm 2 .

Got questions? Get instant answers now!
Practice Key Terms 2

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, University physics volume 3. OpenStax CNX. Nov 04, 2016 Download for free at http://cnx.org/content/col12067/1.4
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'University physics volume 3' conversation and receive update notifications?

Ask