<< Chapter < Page Chapter >> Page >
Figure a is a photograph of a person’s hand holding an electronic stud finder against a wall. Figure b shows the cross section of a wall with a wooden stud behind it. The electronic stud finder is being slid across the wall on the other side. It has capacitor plates that touch the wall.
An electronic stud finder is used to detect wooden studs behind drywall.

The electrical energy stored by a capacitor is also affected by the presence of a dielectric. When the energy stored in an empty capacitor is U 0 , the energy U stored in a capacitor with a dielectric is smaller by a factor of κ ,

U = 1 2 Q 2 C = 1 2 Q 0 2 κ C 0 = 1 κ U 0 .

As a dielectric material sample is brought near an empty charged capacitor, the sample reacts to the electrical field of the charges on the capacitor plates. Just as we learned in Electric Charges and Fields on electrostatics, there will be the induced charges on the surface of the sample; however, they are not free charges like in a conductor, because a perfect insulator does not have freely moving charges. These induced charges on the dielectric surface are of an opposite sign to the free charges on the plates of the capacitor, and so they are attracted by the free charges on the plates. Consequently, the dielectric is “pulled” into the gap, and the work to polarize the dielectric material between the plates is done at the expense of the stored electrical energy, which is reduced, in accordance with [link] .

Inserting a dielectric into an isolated capacitor

An empty 20.0-pF capacitor is charged to a potential difference of 40.0 V. The charging battery is then disconnected, and a piece of Teflon™ with a dielectric constant of 2.1 is inserted to completely fill the space between the capacitor plates (see [link] ). What are the values of (a) the capacitance, (b) the charge of the plate, (c) the potential difference between the plates, and (d) the energy stored in the capacitor with and without dielectric?

Strategy

We identify the original capacitance C 0 = 20.0 pF and the original potential difference V 0 = 40.0 V between the plates. We combine [link] with other relations involving capacitance and substitute.

Solution

  1. The capacitance increases to
    C = κ C 0 = 2.1 ( 20.0 pF ) = 42.0 pF .
  2. Without dielectric, the charge on the plates is
    Q 0 = C 0 V 0 = ( 20.0 pF ) ( 40.0 V ) = 0.8 nC .

    Since the battery is disconnected before the dielectric is inserted, the plate charge is unaffected by the dielectric and remains at 0.8 nC.
  3. With the dielectric, the potential difference becomes
    V = 1 κ V 0 = 1 2.1 40.0 V = 19.0 V .
  4. The stored energy without the dielectric is
    U 0 = 1 2 C 0 V 0 2 = 1 2 ( 20.0 pF ) ( 40.0 V ) 2 = 16.0 nJ .

    With the dielectric inserted, we use [link] to find that the stored energy decreases to
    U = 1 κ U 0 = 1 2.1 16.0 nJ = 7.6 nJ .

Significance

Notice that the effect of a dielectric on the capacitance of a capacitor is a drastic increase of its capacitance. This effect is far more profound than a mere change in the geometry of a capacitor.

Got questions? Get instant answers now!

Check Your Understanding When a dielectric is inserted into an isolated and charged capacitor, the stored energy decreases to 33% of its original value. (a) What is the dielectric constant? (b) How does the capacitance change?

a. 3.0; b. C = 3.0 C 0

Got questions? Get instant answers now!

Summary

  • The capacitance of an empty capacitor is increased by a factor of κ when the space between its plates is completely filled by a dielectric with dielectric constant κ .
  • Each dielectric material has its specific dielectric constant.
  • The energy stored in an empty isolated capacitor is decreased by a factor of κ when the space between its plates is completely filled with a dielectric with dielectric constant κ .

Conceptual questions

Discuss what would happen if a conducting slab rather than a dielectric were inserted into the gap between the capacitor plates.

answers may vary

Got questions? Get instant answers now!

Discuss how the energy stored in an empty but charged capacitor changes when a dielectric is inserted if (a) the capacitor is isolated so that its charge does not change; (b) the capacitor remains connected to a battery so that the potential difference between its plates does not change.

Got questions? Get instant answers now!

Problems

Show that for a given dielectric material, the maximum energy a parallel-plate capacitor can store is directly proportional to the volume of dielectric.

Got questions? Get instant answers now!

An air-filled capacitor is made from two flat parallel plates 1.0 mm apart. The inside area of each plate is 8.0 cm 2 . (a) What is the capacitance of this set of plates? (b) If the region between the plates is filled with a material whose dielectric constant is 6.0, what is the new capacitance?

a. 7.1 pF; b. 42 pF

Got questions? Get instant answers now!

A capacitor is made from two concentric spheres, one with radius 5.00 cm, the other with radius 8.00 cm. (a) What is the capacitance of this set of conductors? (b) If the region between the conductors is filled with a material whose dielectric constant is 6.00, what is the capacitance of the system?

Got questions? Get instant answers now!

A parallel-plate capacitor has charge of magnitude 9.00 μ C on each plate and capacitance 3.00 μ C when there is air between the plates. The plates are separated by 2.00 mm. With the charge on the plates kept constant, a dielectric with κ = 5 is inserted between the plates, completely filling the volume between the plates. (a) What is the potential difference between the plates of the capacitor, before and after the dielectric has been inserted? (b) What is the electrical field at the point midway between the plates before and after the dielectric is inserted?

a. before 3.00 V; after 0.600 V; b. before 1500 V/m; after 300 V/m

Got questions? Get instant answers now!

Some cell walls in the human body have a layer of negative charge on the inside surface. Suppose that the surface charge densities are ± 0.5 0 × 1 0 −3 C / m 2 , the cell wall is 5. 0 × 1 0 −9 m thick, and the cell wall material has a dielectric constant of κ = 5.4 . (a) Find the magnitude of the electric field in the wall between two charge layers. (b) Find the potential difference between the inside and the outside of the cell. Which is at higher potential? (c) A typical cell in the human body has volume 10 −16 m 3 . Estimate the total electrical field energy stored in the wall of a cell of this size when assuming that the cell is spherical. ( Hint : Calculate the volume of the cell wall.)

Got questions? Get instant answers now!

A parallel-plate capacitor with only air between its plates is charged by connecting the capacitor to a battery. The capacitor is then disconnected from the battery, without any of the charge leaving the plates. (a) A voltmeter reads 45.0 V when placed across the capacitor. When a dielectric is inserted between the plates, completely filling the space, the voltmeter reads 11.5 V. What is the dielectric constant of the material? (b) What will the voltmeter read if the dielectric is now pulled away out so it fills only one-third of the space between the plates?

a. 3.91; b. 22.8 V

Got questions? Get instant answers now!

Questions & Answers

calculate molarity of NaOH solution when 25.0ml of NaOH titrated with 27.2ml of 0.2m H2SO4
Gasin Reply
what's Thermochemistry
rhoda Reply
the study of the heat energy which is associated with chemical reactions
Kaddija
How was CH4 and o2 was able to produce (Co2)and (H2o
Edafe Reply
explain please
Victory
First twenty elements with their valences
Martine Reply
what is chemistry
asue Reply
what is atom
asue
what is the best way to define periodic table for jamb
Damilola Reply
what is the change of matter from one state to another
Elijah Reply
what is isolation of organic compounds
IKyernum Reply
what is atomic radius
ThankGod Reply
Read Chapter 6, section 5
Dr
Read Chapter 6, section 5
Kareem
Atomic radius is the radius of the atom and is also called the orbital radius
Kareem
atomic radius is the distance between the nucleus of an atom and its valence shell
Amos
Read Chapter 6, section 5
paulino
Bohr's model of the theory atom
Ayom Reply
is there a question?
Dr
when a gas is compressed why it becomes hot?
ATOMIC
It has no oxygen then
Goldyei
read the chapter on thermochemistry...the sections on "PV" work and the First Law of Thermodynamics should help..
Dr
Which element react with water
Mukthar Reply
Mgo
Ibeh
an increase in the pressure of a gas results in the decrease of its
Valentina Reply
definition of the periodic table
Cosmos Reply
What is the lkenes
Da Reply
what were atoms composed of?
Moses Reply
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 1

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, University physics volume 2. OpenStax CNX. Oct 06, 2016 Download for free at http://cnx.org/content/col12074/1.3
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'University physics volume 2' conversation and receive update notifications?

Ask