7.1 Failure and strength of materials  (Page 2/3)

A ductile material is a substance that can undergo large plastic deformation without fracturing. Many metals are very ductile and they can be drawn into wires, e.g. copper, silver, aluminium and gold.

A malleable material is a substance that can easily undergo plastic deformation by hammering or rolling. Again, metals are malleable substances, e.g. copper can be hammered into sheets and aluminium can be rolled into aluminium foil.

A brittle material fractures with very little or no plastic deformation. Glassware and ceramics are brittle.

Structure and failure of materials

Many substances fail because they have a weakness in their atomic structure. There are a number of problems that can cause these weaknesses in structure. These are vacancies, dislocations, grain boundaries and impurities.

Vacancies occur when there are spaces in the structure of a crystalline solid. These vacancies cause weakness and such materials often fail at these places. Think about bricks in a wall, if you started removing bricks the wall would get weaker.

Dislocations result in weakened bonding between layers of atoms in a crystal lattice and this creates a critical boundary. If sufficient force is applied along the boundary, it can break the weakened bonds, allowing the two sides of the crystal to slide against one another. The two pieces of the crystal keep their shape and structure.

Impurities in a crystal structure can cause a weak region in the crystal lattice around the impurity. Like vacancies, the substance often fail from these places in the lattice. This you can think of as bricks in a wall which don't fit properly, they are the wrong kind of bricks (atoms) to make the structure strong.

Controlling the properties of materials

There are a number of processes that can be used to make materials less likely to fail. We shall look at a few methods in this section.

Cold working

Cold working is a process in which a metal is strengthened by repeatedly being reshaped. This is carried out at a temperature below the melting point of the metal. The repeated shaping of the metal results in dislocations which then prevent restrict the motion of dislocations in the metal. Cold working increases the strength of the metal but in so doing, the metal loses its ductility. We say the metal is work-hardened .

Annealing

Annealing is a process of heating and cooling a material to relax the crystal structure and reduce weakness due to impurities and structural flaws. During annealing, the material is heated to a high temperature that is below the material's melting point. At a sufficiently high temperature, atoms with weakened bonds can rearrange themselves into a stronger structure. Slowly cooling the material ensures that the atoms will remain in these stronger locations. Annealing is often used before cold working.

Introduction of impurities

Most pure metals are relatively weak because dislocations can move easily within them. However, if impurities are added to a metal (e.g., carbon is added to an iron sample), they can disturb the regular structure of the metal and so prevent dislocations from spreading. This makes the metal stronger.