<< Chapter < Page Chapter >> Page >
Index of refraction n In selected media at various wavelengths
Medium Red (660 nm) Orange (610 nm) Yellow (580 nm) Green (550 nm) Blue (470 nm) Violet (410 nm)
Water 1.331 1.332 1.333 1.335 1.338 1.342
Diamond 2.410 2.415 2.417 2.426 2.444 2.458
Glass, crown 1.512 1.514 1.518 1.519 1.524 1.530
Glass, flint 1.662 1.665 1.667 1.674 1.684 1.698
Polystyrene 1.488 1.490 1.492 1.493 1.499 1.506
Quartz, fused 1.455 1.456 1.458 1.459 1.462 1.468
Figure (a) shows a triangle representing a prism and a pure wavelength of incident light falling onto it and getting refracted at both sides of the prism. The refracted ray runs parallel to the base of the prism and then emerges after getting refracted from the other surface. Figure (b) shows a triangle representing a prism and an incident white light falling onto it and getting refracted at the first surface with two refracted rays with slightly different angles of separation. The refracted rays, on falling on the second surface, refract with various angles of refraction. A sequence of red to violet is produced when light emerges out of the prism. Red at 760 nanometers and violet at 380 nanometers.
(a) A pure wavelength of light falls onto a prism and is refracted at both surfaces. (b) White light is dispersed by the prism (shown exaggerated). Since the index of refraction varies with wavelength, the angles of refraction vary with wavelength. A sequence of red to violet is produced, because the index of refraction increases steadily with decreasing wavelength.

Rainbows are produced by a combination of refraction and reflection. You may have noticed that you see a rainbow only when you look away from the sun. Light enters a drop of water and is reflected from the back of the drop, as shown in [link] . The light is refracted both as it enters and as it leaves the drop. Since the index of refraction of water varies with wavelength, the light is dispersed, and a rainbow is observed, as shown in [link] (a). (There is no dispersion caused by reflection at the back surface, since the law of reflection does not depend on wavelength.) The actual rainbow of colors seen by an observer depends on the myriad of rays being refracted and reflected toward the observer’s eyes from numerous drops of water. The effect is most spectacular when the background is dark, as in stormy weather, but can also be observed in waterfalls and lawn sprinklers. The arc of a rainbow comes from the need to be looking at a specific angle relative to the direction of the sun, as illustrated in [link] (b). (If there are two reflections of light within the water drop, another “secondary” rainbow is produced. This rare event produces an arc that lies above the primary rainbow arc—see [link] (c).)

Rainbows

Rainbows are produced by a combination of refraction and reflection.

Sun light incident on a spherical water droplet gets refracted at various angles. The refracted rays further undergo total internal reflection and when they leave the water droplet, a sequence of colors ranging from violet to red is formed.
Part of the light falling on this water drop enters and is reflected from the back of the drop. This light is refracted and dispersed both as it enters and as it leaves the drop.
In figure (a) sunlight is incident on two water droplets close to one another. The incident rays undergo refraction and total internal reflection. From the first droplet, violet color emerges and from the second, red emerges. A woman observes from a distance, the band of seven colors with red on top and violet at the bottom. Two rays each from red and violet reach the observer’s eyes. The angle of separation between the incident light and the emerging red light is theta. In figure (b), a man looks at the rainbow, which is in the shape of an arc. A parallel beam of blue colored rays fall on the rainbow at different positions and then reaches the observer, each ray making the same angle theta with the incident ray. The rays reaching the observer are red in color. Figure (c) shows a spectacular double rainbow in the sky with white clouds as a backdrop.
(a) Different colors emerge in different directions, and so you must look at different locations to see the various colors of a rainbow. (b) The arc of a rainbow results from the fact that a line between the observer and any point on the arc must make the correct angle with the parallel rays of sunlight to receive the refracted rays. (c) Double rainbow. (credit: Nicholas, Wikimedia Commons)

Dispersion may produce beautiful rainbows, but it can cause problems in optical systems. White light used to transmit messages in a fiber is dispersed, spreading out in time and eventually overlapping with other messages. Since a laser produces a nearly pure wavelength, its light experiences little dispersion, an advantage over white light for transmission of information. In contrast, dispersion of electromagnetic waves coming to us from outer space can be used to determine the amount of matter they pass through. As with many phenomena, dispersion can be useful or a nuisance, depending on the situation and our human goals.

Phet explorations: geometric optics

How does a lens form an image? See how light rays are refracted by a lens. Watch how the image changes when you adjust the focal length of the lens, move the object, move the lens, or move the screen.

Geometric Optics

Section summary

  • The spreading of white light into its full spectrum of wavelengths is called dispersion.
  • Rainbows are produced by a combination of refraction and reflection and involve the dispersion of sunlight into a continuous distribution of colors.
  • Dispersion produces beautiful rainbows but also causes problems in certain optical systems.

Problems&Exercises

(a) What is the ratio of the speed of red light to violet light in diamond, based on [link] ? (b) What is this ratio in polystyrene? (c) Which is more dispersive?

Got questions? Get instant answers now!

A beam of white light goes from air into water at an incident angle of 75 . size 12{"75" "." 0°} {} . At what angles are the red (660 nm) and violet (410 nm) parts of the light refracted?

46 . , red; 46 . , violet

Got questions? Get instant answers now!

By how much do the critical angles for red (660 nm) and violet (410 nm) light differ in a diamond surrounded by air?

Got questions? Get instant answers now!

(a) A narrow beam of light containing yellow (580 nm) and green (550 nm) wavelengths goes from polystyrene to air, striking the surface at a 30 . size 12{"30" "." 0°} {} incident angle. What is the angle between the colors when they emerge? (b) How far would they have to travel to be separated by 1.00 mm?

(a) 0 . 043º size 12{0 "." "043"°} {}

(b) 1 . 33 m size 12{1 "." "33"" m"} {}

Got questions? Get instant answers now!

A parallel beam of light containing orange (610 nm) and violet (410 nm) wavelengths goes from fused quartz to water, striking the surface between them at a 60 . size 12{"60" "." 0°} {} incident angle. What is the angle between the two colors in water?

Got questions? Get instant answers now!

A ray of 610 nm light goes from air into fused quartz at an incident angle of 55 . size 12{"55" "." 0°} {} . At what incident angle must 470 nm light enter flint glass to have the same angle of refraction?

71.3º size 12{"71" "." 3°} {}

Got questions? Get instant answers now!

A narrow beam of light containing red (660 nm) and blue (470 nm) wavelengths travels from air through a 1.00 cm thick flat piece of crown glass and back to air again. The beam strikes at a 30 . size 12{"30" "." 0°} {} incident angle. (a) At what angles do the two colors emerge? (b) By what distance are the red and blue separated when they emerge?

Got questions? Get instant answers now!

A narrow beam of white light enters a prism made of crown glass at a 45 . size 12{"45" "." 0°} {} incident angle, as shown in [link] . At what angles, θ R and θ V , do the red (660 nm) and violet (410 nm) components of the light emerge from the prism?

A blue incident light ray at an angle of incidence equal to 45 degrees falls on an equilateral triangular prism with angles each equal to 60 degrees. On falling onto the first surface, the ray refracts and splits into red and violet rays. These rays falling onto the second surface and emerge from the prism. Red with 660 nanometers and violet with 410 nanometers.
This prism will disperse the white light into a rainbow of colors. The incident angle is 45 . , and the angles at which the red and violet light emerge are θ R and θ V size 12{q rSub { size 8{V} } } {} .

53.5º , red; size 12{"53" "." 5°," red;"} {} 55.2º , violet size 12{"55" "." 2°," violet"} {}

Got questions? Get instant answers now!

Questions & Answers

differentiate between demand and supply giving examples
Lambiv Reply
differentiated between demand and supply using examples
Lambiv
what is labour ?
Lambiv
how will I do?
Venny Reply
how is the graph works?I don't fully understand
Rezat Reply
information
Eliyee
devaluation
Eliyee
t
WARKISA
hi guys good evening to all
Lambiv
multiple choice question
Aster Reply
appreciation
Eliyee
explain perfect market
Lindiwe Reply
In economics, a perfect market refers to a theoretical construct where all participants have perfect information, goods are homogenous, there are no barriers to entry or exit, and prices are determined solely by supply and demand. It's an idealized model used for analysis,
Ezea
What is ceteris paribus?
Shukri Reply
other things being equal
AI-Robot
When MP₁ becomes negative, TP start to decline. Extuples Suppose that the short-run production function of certain cut-flower firm is given by: Q=4KL-0.6K2 - 0.112 • Where is quantity of cut flower produced, I is labour input and K is fixed capital input (K-5). Determine the average product of lab
Kelo
Extuples Suppose that the short-run production function of certain cut-flower firm is given by: Q=4KL-0.6K2 - 0.112 • Where is quantity of cut flower produced, I is labour input and K is fixed capital input (K-5). Determine the average product of labour (APL) and marginal product of labour (MPL)
Kelo
yes,thank you
Shukri
Can I ask you other question?
Shukri
what is monopoly mean?
Habtamu Reply
What is different between quantity demand and demand?
Shukri Reply
Quantity demanded refers to the specific amount of a good or service that consumers are willing and able to purchase at a give price and within a specific time period. Demand, on the other hand, is a broader concept that encompasses the entire relationship between price and quantity demanded
Ezea
ok
Shukri
how do you save a country economic situation when it's falling apart
Lilia Reply
what is the difference between economic growth and development
Fiker Reply
Economic growth as an increase in the production and consumption of goods and services within an economy.but Economic development as a broader concept that encompasses not only economic growth but also social & human well being.
Shukri
production function means
Jabir
What do you think is more important to focus on when considering inequality ?
Abdisa Reply
any question about economics?
Awais Reply
sir...I just want to ask one question... Define the term contract curve? if you are free please help me to find this answer 🙏
Asui
it is a curve that we get after connecting the pareto optimal combinations of two consumers after their mutually beneficial trade offs
Awais
thank you so much 👍 sir
Asui
In economics, the contract curve refers to the set of points in an Edgeworth box diagram where both parties involved in a trade cannot be made better off without making one of them worse off. It represents the Pareto efficient allocations of goods between two individuals or entities, where neither p
Cornelius
In economics, the contract curve refers to the set of points in an Edgeworth box diagram where both parties involved in a trade cannot be made better off without making one of them worse off. It represents the Pareto efficient allocations of goods between two individuals or entities,
Cornelius
Suppose a consumer consuming two commodities X and Y has The following utility function u=X0.4 Y0.6. If the price of the X and Y are 2 and 3 respectively and income Constraint is birr 50. A,Calculate quantities of x and y which maximize utility. B,Calculate value of Lagrange multiplier. C,Calculate quantities of X and Y consumed with a given price. D,alculate optimum level of output .
Feyisa Reply
Answer
Feyisa
c
Jabir
the market for lemon has 10 potential consumers, each having an individual demand curve p=101-10Qi, where p is price in dollar's per cup and Qi is the number of cups demanded per week by the i th consumer.Find the market demand curve using algebra. Draw an individual demand curve and the market dema
Gsbwnw Reply
suppose the production function is given by ( L, K)=L¼K¾.assuming capital is fixed find APL and MPL. consider the following short run production function:Q=6L²-0.4L³ a) find the value of L that maximizes output b)find the value of L that maximizes marginal product
Abdureman
types of unemployment
Yomi Reply
What is the difference between perfect competition and monopolistic competition?
Mohammed
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 2

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, College physics. OpenStax CNX. Jul 27, 2015 Download for free at http://legacy.cnx.org/content/col11406/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'College physics' conversation and receive update notifications?

Ask