<< Chapter < Page Chapter >> Page >
A hopping kangaroo is shown landing on the ground in one photograph and in the air just after taking another jump in the second photograph.
The work done by the ground upon the kangaroo reduces its kinetic energy to zero as it lands. However, by applying the force of the ground on the hind legs over a longer distance, the impact on the bones is reduced. (credit: Chris Samuel, Flickr)

Finding the speed of a roller coaster from its height

(a) What is the final speed of the roller coaster shown in [link] if it starts from rest at the top of the 20.0 m hill and work done by frictional forces is negligible? (b) What is its final speed (again assuming negligible friction) if its initial speed is 5.00 m/s?

A roller coaster track is shown with a car about to go downhill. The initial height of the roller coaster car on the track is twenty-five meters from the lowest part of the track and its speed v sub zero is equal to zero. The roller coaster’s height from the level part of the track is twenty meters. The finish point of the car is on the level part of the track and the speed at that point is unknown.
The speed of a roller coaster increases as gravity pulls it downhill and is greatest at its lowest point. Viewed in terms of energy, the roller-coaster-Earth system’s gravitational potential energy is converted to kinetic energy. If work done by friction is negligible, all Δ PE g size 12{Δ"PE" rSub { size 8{g} } } {} is converted to KE size 12{"KE"} {} .

Strategy

The roller coaster loses potential energy as it goes downhill. We neglect friction, so that the remaining force exerted by the track is the normal force, which is perpendicular to the direction of motion and does no work. The net work on the roller coaster is then done by gravity alone. The loss of gravitational potential energy from moving downward through a distance h size 12{h} {} equals the gain in kinetic energy. This can be written in equation form as Δ PE g = Δ KE size 12{ - Δ"PE" rSub { size 8{g} } =Δ"KE"} {} . Using the equations for PE g size 12{"PE" rSub { size 8{g} } } {} and KE size 12{"KE"} {} , we can solve for the final speed v size 12{v} {} , which is the desired quantity.

Solution for (a)

Here the initial kinetic energy is zero, so that ΔKE = 1 2 mv 2 . The equation for change in potential energy states that ΔPE g = mgh . Since h is negative in this case, we will rewrite this as ΔPE g = mg h to show the minus sign clearly. Thus,

Δ PE g = Δ KE size 12{ - Δ"PE" rSub { size 8{g} } =Δ"KE"} {}

becomes

mg h = 1 2 mv 2 . size 12{ ital "mg" lline h rline = { {1} over {2} } ital "mv" rSup { size 8{2} } "." } {}

Solving for v size 12{v} {} , we find that mass cancels and that

v = 2 g h . size 12{v= sqrt {2g lline h rline } } {}

Substituting known values,

v = 2 9 . 80 m /s 2 20.0 m = 19 .8 m/s. alignl { stack { size 12{v= sqrt {2 left (9 "." "80"" m/s" rSup { size 8{2} } right ) left ("20" "." 0" m" right )} } {} # " "=" 19" "." "8 m/s" "." {}} } {}

Solution for (b)

Again ΔPE g = ΔKE size 12{ - Δ"PE" rSub { size 8{g} } =Δ"KE"} {} . In this case there is initial kinetic energy, so ΔKE = 1 2 m v 2 1 2 m v 0 2 size 12{Δ"KE"= { {1} over {2} } ital "mv" rSup { size 8{2} } - { {1} over {2} } ital "mv" rSub { size 8{0} rSup { size 8{2} } } } {} . Thus,

mg h = 1 2 mv 2 1 2 m v 0 2 . size 12{ ital "mg" lline h rline = { {1} over {2} } ital "mv" rSup { size 8{2} } - { {1} over {2} } ital "mv" rSub { size 8{0} rSup { size 8{2} } } "." } {}

Rearranging gives

1 2 mv 2 = mg h + 1 2 m v 0 2 . size 12{ { {1} over {2} } ital "mv" rSup { size 8{2} } = ital "mg" lline h rline + { {1} over {2} } ital "mv" rSub { size 8{0} rSup { size 8{2} } } "." } {}

This means that the final kinetic energy is the sum of the initial kinetic energy and the gravitational potential energy. Mass again cancels, and

v = 2 g h + v 0 2 . size 12{v= sqrt {2g lline h rline +v rSub { size 8{0} rSup { size 8{2} } } } } {}

This equation is very similar to the kinematics equation v = v 0 2 + 2 ad size 12{v= sqrt {v rSub { size 8{0} } rSup { size 8{2} } +2 ital "ad"} } {} , but it is more general—the kinematics equation is valid only for constant acceleration, whereas our equation above is valid for any path regardless of whether the object moves with a constant acceleration. Now, substituting known values gives

v = 2 ( 9 . 80 m/s 2 ) ( 20 .0 m ) + ( 5 .00 m/s ) 2 = 20.4 m/s. alignl { stack { size 12{v= sqrt {2 \( 9 "." "80"" m/s" rSup { size 8{2} } \) \( "20" "." 0" m" \) + \( 5 "." "00"" m/s" \) rSup { size 8{2} } } } {} #" "=" 20" "." "4 m/s" "." {} } } {}

Discussion and Implications

First, note that mass cancels. This is quite consistent with observations made in Falling Objects that all objects fall at the same rate if friction is negligible. Second, only the speed of the roller coaster is considered; there is no information about its direction at any point. This reveals another general truth. When friction is negligible, the speed of a falling body depends only on its initial speed and height, and not on its mass or the path taken. For example, the roller coaster will have the same final speed whether it falls 20.0 m straight down or takes a more complicated path like the one in the figure. Third, and perhaps unexpectedly, the final speed in part (b) is greater than in part (a), but by far less than 5.00 m/s. Finally, note that speed can be found at any height along the way by simply using the appropriate value of h size 12{h} {} at the point of interest.

Questions & Answers

A golfer on a fairway is 70 m away from the green, which sits below the level of the fairway by 20 m. If the golfer hits the ball at an angle of 40° with an initial speed of 20 m/s, how close to the green does she come?
Aislinn Reply
cm
tijani
what is titration
John Reply
what is physics
Siyaka Reply
A mouse of mass 200 g falls 100 m down a vertical mine shaft and lands at the bottom with a speed of 8.0 m/s. During its fall, how much work is done on the mouse by air resistance
Jude Reply
Can you compute that for me. Ty
Jude
what is the dimension formula of energy?
David Reply
what is viscosity?
David
what is inorganic
emma Reply
what is chemistry
Youesf Reply
what is inorganic
emma
Chemistry is a branch of science that deals with the study of matter,it composition,it structure and the changes it undergoes
Adjei
please, I'm a physics student and I need help in physics
Adjanou
chemistry could also be understood like the sexual attraction/repulsion of the male and female elements. the reaction varies depending on the energy differences of each given gender. + masculine -female.
Pedro
A ball is thrown straight up.it passes a 2.0m high window 7.50 m off the ground on it path up and takes 1.30 s to go past the window.what was the ball initial velocity
Krampah Reply
2. A sled plus passenger with total mass 50 kg is pulled 20 m across the snow (0.20) at constant velocity by a force directed 25° above the horizontal. Calculate (a) the work of the applied force, (b) the work of friction, and (c) the total work.
Sahid Reply
you have been hired as an espert witness in a court case involving an automobile accident. the accident involved car A of mass 1500kg which crashed into stationary car B of mass 1100kg. the driver of car A applied his brakes 15 m before he skidded and crashed into car B. after the collision, car A s
Samuel Reply
can someone explain to me, an ignorant high school student, why the trend of the graph doesn't follow the fact that the higher frequency a sound wave is, the more power it is, hence, making me think the phons output would follow this general trend?
Joseph Reply
Nevermind i just realied that the graph is the phons output for a person with normal hearing and not just the phons output of the sound waves power, I should read the entire thing next time
Joseph
Follow up question, does anyone know where I can find a graph that accuretly depicts the actual relative "power" output of sound over its frequency instead of just humans hearing
Joseph
"Generation of electrical energy from sound energy | IEEE Conference Publication | IEEE Xplore" ***ieeexplore.ieee.org/document/7150687?reload=true
Ryan
what's motion
Maurice Reply
what are the types of wave
Maurice
answer
Magreth
progressive wave
Magreth
hello friend how are you
Muhammad Reply
fine, how about you?
Mohammed
hi
Mujahid
A string is 3.00 m long with a mass of 5.00 g. The string is held taut with a tension of 500.00 N applied to the string. A pulse is sent down the string. How long does it take the pulse to travel the 3.00 m of the string?
yasuo Reply
Who can show me the full solution in this problem?
Reofrir Reply
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 1

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, College physics. OpenStax CNX. Jul 27, 2015 Download for free at http://legacy.cnx.org/content/col11406/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'College physics' conversation and receive update notifications?

Ask