<< Chapter < Page Chapter >> Page >
h = v 0 y 2 2 g . size 12{y= { {v rSub { size 8{0y} } rSup { size 8{2} } } over {2g} } "." } {}

This equation defines the maximum height of a projectile and depends only on the vertical component of the initial velocity.

Defining a coordinate system

It is important to set up a coordinate system when analyzing projectile motion. One part of defining the coordinate system is to define an origin for the x size 12{x} {} and y size 12{y} {} positions. Often, it is convenient to choose the initial position of the object as the origin such that x 0 = 0 size 12{x rSub { size 8{0} } =0} {} and y 0 = 0 size 12{y rSub { size 8{0} } =0} {} . It is also important to define the positive and negative directions in the x size 12{x} {} and y size 12{y} {} directions. Typically, we define the positive vertical direction as upwards, and the positive horizontal direction is usually the direction of the object’s motion. When this is the case, the vertical acceleration, g size 12{g} {} , takes a negative value (since it is directed downwards towards the Earth). However, it is occasionally useful to define the coordinates differently. For example, if you are analyzing the motion of a ball thrown downwards from the top of a cliff, it may make sense to define the positive direction downwards since the motion of the ball is solely in the downwards direction. If this is the case, g size 12{g} {} takes a positive value.

Calculating projectile motion: hot rock projectile

Kilauea in Hawaii is the world’s most continuously active volcano. Very active volcanoes characteristically eject red-hot rocks and lava rather than smoke and ash. Suppose a large rock is ejected from the volcano with a speed of 25.0 m/s and at an angle 35.0º size 12{"35"°} {} above the horizontal, as shown in [link] . The rock strikes the side of the volcano at an altitude 20.0 m lower than its starting point. (a) Calculate the time it takes the rock to follow this path. (b) What are the magnitude and direction of the rock’s velocity at impact?

The trajectory of a rock ejected from a volcano is shown. The initial velocity of rock v zero is equal to twenty five meters per second and it makes an angle of thirty five degrees with the horizontal x axis. The figure shows rock falling down a height of twenty meters below the volcano level. The velocity at this point is v which makes an angle of theta with horizontal x axis. The direction of v is south east.
The trajectory of a rock ejected from the Kilauea volcano.

Strategy

Again, resolving this two-dimensional motion into two independent one-dimensional motions will allow us to solve for the desired quantities. The time a projectile is in the air is governed by its vertical motion alone. We will solve for t size 12{t} {} first. While the rock is rising and falling vertically, the horizontal motion continues at a constant velocity. This example asks for the final velocity. Thus, the vertical and horizontal results will be recombined to obtain v size 12{v} {} and θ v size 12{θ rSub { size 8{v} } } {} at the final time t size 12{t} {} determined in the first part of the example.

Solution for (a)

While the rock is in the air, it rises and then falls to a final position 20.0 m lower than its starting altitude. We can find the time for this by using

y = y 0 + v 0 y t 1 2 gt 2 . size 12{y=y rSub { size 8{0} } +v rSub { size 8{0y} } t - { {1} over {2} } ital "gt" rSup { size 8{2} } "."} {}

If we take the initial position y 0 size 12{y rSub { size 8{0} } } {} to be zero, then the final position is y = 20 .0 m . size 12{y= - "20" "." 0" m" "." } {} Now the initial vertical velocity is the vertical component of the initial velocity, found from v 0 y = v 0 sin θ 0 size 12{v rSub { size 8{0y} } =v rSub { size 8{0} } "sin"θ rSub { size 8{0} } } {} = ( 25 . 0 m/s size 12{"25" "." "0 m/s"} {} )( sin 35.0º size 12{"sin 35"°} {} ) = 14 . 3 m/s size 12{"14" "." "3 m/s"} {} . Substituting known values yields

20 . 0 m = ( 14 . 3 m/s ) t 4 . 90 m/s 2 t 2 . size 12{ - "20" "." 0" m"= \( "14" "." 3" m/s" \) t - left (4 "." "90"" m/s" rSup { size 8{2} } right )t rSup { size 8{2} } "."} {}

Rearranging terms gives a quadratic equation in t size 12{t} {} :

4 . 90 m/s 2 t 2 14 . 3 m/s t 20.0 m = 0. size 12{ left (4 "." "90"" m/s" rSup { size 8{2} } right )t rSup { size 8{2} } - left ("14" "." "3 m/s" right )t - left ("20" "." 0" m" right )=0.} {}

This expression is a quadratic equation of the form at 2 + bt + c = 0 size 12{ ital "at" rSup { size 8{2} } + ital "bt"+c=0} {} , where the constants are a = 4.90 , b = 14.3 , and c = 20.0. Its solutions are given by the quadratic formula:

Questions & Answers

if three forces F1.f2 .f3 act at a point on a Cartesian plane in the daigram .....so if the question says write down the x and y components ..... I really don't understand
Syamthanda Reply
hey , can you please explain oxidation reaction & redox ?
Boitumelo Reply
hey , can you please explain oxidation reaction and redox ?
Boitumelo
for grade 12 or grade 11?
Sibulele
the value of V1 and V2
Tumelo Reply
advantages of electrons in a circuit
Rethabile Reply
we're do you find electromagnetism past papers
Ntombifuthi
what a normal force
Tholulwazi Reply
it is the force or component of the force that the surface exert on an object incontact with it and which acts perpendicular to the surface
Sihle
what is physics?
Petrus Reply
what is the half reaction of Potassium and chlorine
Anna Reply
how to calculate coefficient of static friction
Lisa Reply
how to calculate static friction
Lisa
How to calculate a current
Tumelo
how to calculate the magnitude of horizontal component of the applied force
Mogano
How to calculate force
Monambi
a structure of a thermocouple used to measure inner temperature
Anna Reply
a fixed gas of a mass is held at standard pressure temperature of 15 degrees Celsius .Calculate the temperature of the gas in Celsius if the pressure is changed to 2×10 to the power 4
Amahle Reply
How is energy being used in bonding?
Raymond Reply
what is acceleration
Syamthanda Reply
a rate of change in velocity of an object whith respect to time
Khuthadzo
how can we find the moment of torque of a circular object
Kidist
Acceleration is a rate of change in velocity.
Justice
t =r×f
Khuthadzo
how to calculate tension by substitution
Precious Reply
hi
Shongi
hi
Leago
use fnet method. how many obects are being calculated ?
Khuthadzo
khuthadzo hii
Hulisani
how to calculate acceleration and tension force
Lungile Reply
you use Fnet equals ma , newtoms second law formula
Masego
please help me with vectors in two dimensions
Mulaudzi Reply
how to calculate normal force
Mulaudzi
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 7

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, College physics. OpenStax CNX. Jul 27, 2015 Download for free at http://legacy.cnx.org/content/col11406/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'College physics' conversation and receive update notifications?

Ask