1. Home
  2. College physics for ap® courses
  3. Rotational motion and angular
  4. Dynamics of rotational motion:

10.3 Dynamics of rotational motion: rotational inertia  (Page 5/9)

<< Chapter < Page
  College physics for ap® courses     Page 5 / 9
Chapter >> Page >

Test prep for ap courses

A piece of wood can be carved by spinning it on a motorized lathe and holding a sharp chisel to the edge of the wood as it spins. How does the angular velocity of a piece of wood with a radius of 0.2 m spinning on a lathe change when a chisel is held to the wood's edge with a force of 50 N?

  1. It increases by 0.1 N•m multiplied by the moment of inertia of the wood.
  2. It decreases by 0.1 N•m divided by the moment of inertia of the wood-and-lathe system.
  3. It decreases by 0.1 N•m multiplied by the moment of inertia of the wood.
  4. It decreases by 0.1 m/s 2 .

(b)

Got questions? Get instant answers now!

A Ferris wheel is loaded with people in the chairs at the following positions: 4 o'clock, 1 o'clock, 9 o'clock, and 6 o'clock. As the wheel begins to turn, what forces are acting on the system? How will each force affect the angular velocity and angular momentum?

Got questions? Get instant answers now!

A lever is placed on a fulcrum. A rock is placed on the left end of the lever and a downward (clockwise) force is applied to the right end of the lever. What measurements would be most effective to help you determine the angular momentum of the system? (Assume the lever itself has negligible mass.)

  1. the angular velocity and mass of the rock
  2. the angular velocity and mass of the rock, and the radius of the lever
  3. the velocity of the force, the radius of the lever, and the mass of the rock
  4. the mass of the rock, the length of the lever on both sides of the fulcrum, and the force applied on the right side of the lever

(d)

Got questions? Get instant answers now!

You can use the following setup to determine angular acceleration and angular momentum: A lever is placed on a fulcrum. A rock is placed on the left end of the lever and a known downward (clockwise) force is applied to the right end of the lever. What calculations would you perform? How would you account for gravity in your calculations?

Got questions? Get instant answers now!

Consider two sizes of disk, both of mass M . One size of disk has radius R ; the other has radius 2 R . System A consists of two of the larger disks rigidly connected to each other with a common axis of rotation. System B consists of one of the larger disks and a number of the smaller disks rigidly connected with a common axis of rotation. If the moment of inertia for system A equals the moment of inertia for system B, how many of the smaller disks are in system B?

  1. 1
  2. 2
  3. 3
  4. 4

(d)

You are given a thin rod of length 1.0 m and mass 2.0 kg, a small lead weight of 0.50 kg, and a not-so-small lead weight of 1.0 kg. The rod has three holes, one in each end and one through the middle, which may either hold a pivot point or one of the small lead weights.

Got questions? Get instant answers now!

How do you arrange these objects so that the resulting system has the maximum possible moment of inertia? What is that moment of inertia?

Got questions? Get instant answers now!

Section summary

  • The farther the force is applied from the pivot, the greater is the angular acceleration; angular acceleration is inversely proportional to mass.
  • If we exert a force F size 12{F} {} on a point mass m size 12{m} {} that is at a distance r size 12{r} {} from a pivot point and because the force is perpendicular to r size 12{r} {} , an acceleration a = F/m size 12{F} {} is obtained in the direction of F size 12{F} {} . We can rearrange this equation such that
    F = ma , size 12{F} {","}

    and then look for ways to relate this expression to expressions for rotational quantities. We note that a = rα size 12{F} {} , and we substitute this expression into F=ma size 12{F} {} , yielding

    F=mrα size 12{F} {}
  • Torque is the turning effectiveness of a force. In this case, because F size 12{F} {} is perpendicular to r size 12{r} {} , torque is simply τ = rF size 12{F} {} . If we multiply both sides of the equation above by r size 12{r} {} , we get torque on the left-hand side. That is,
    rF = mr 2 α size 12{ ital "rF"= ital "mr" rSup { size 8{2} } α} {}

    or

    τ = mr 2 α . size 12{τ= ital "mr" rSup { size 8{2} } α "." } {}
  • The moment of inertia I size 12{I} {} of an object is the sum of MR 2 size 12{ ital "MR" rSup { size 8{2} } } {} for all the point masses of which it is composed. That is,
    I = ∑ mr 2 . size 12{I= sum ital "mr" rSup { size 8{2} } "." } {}
  • The general relationship among torque, moment of inertia, and angular acceleration is
    τ = Iα size 12{τ=Iα} {}

    or

    α = net τ I ⋅ size 12{α= { { ital "net"`τ} over {I} } cdot } {}

Questions & Answers

it is the relatively stable flow of income
Chidubem Reply
what is circular flow of income
Divine Reply
branches of macroeconomics
SHEDRACK Reply
what is Flexible exchang rate?
poudel Reply
is gdp a reliable measurement of wealth
Atega Reply
introduction to econometrics
Husseini Reply
Hi
mostafa
hi
LEMLEM
hello
Sammol
hi
Mahesh
bi
Ruqayat
hi
Ruqayat
Hi fellas
Nyawa
hey
Sammol
hi
God
hello
Jahara
Good morning
Jorge
hi
abubakar
hi
Nmesoma
hi
Mahesh
Hi
Tom
Why is unemployment rate never zero at full employment?
Priyanka Reply
bcoz of existence of frictional unemployment in our economy.
Umashankar
what is flexible exchang rate?
poudel
due to existence of the pple with disabilities
Abdulraufu
the demand of a good rises, causing the demand for another good to fall
Rushawn Reply
is it possible to leave every good at the same level
Joseph
I don't think so. because check it, if the demand for chicken increases, people will no longer consume fish like they used to causing a fall in the demand for fish
Anuolu
is not really possible to let the value of a goods to be same at the same time.....
Salome
Suppose the inflation rate is 6%, does it mean that all the goods you purchase will cost 6% more than previous year? Provide with reasoning.
Geetha Reply
Not necessarily. To measure the inflation rate economists normally use an averaged price index of a basket of certain goods. So if you purchase goods included in the basket, you will notice that you pay 6% more, otherwise not necessarily.
Waeth
discus major problems of macroeconomics
Alii Reply
what is the problem of macroeconomics
Yoal
Economic growth Stable prices and low unemployment
Ephraim
explain inflationcause and itis degre
Miresa Reply
what is inflation
Getu
increase in general price levels
WEETO
Good day How do I calculate this question: C= 100+5yd G= 2000 T= 2000 I(planned)=200. Suppose the actual output is 3000. What is the level of planned expenditures at this level of output?
Chisomo Reply
how to calculate actual output?
Chisomo
how to calculate the equilibrium income
Beshir
Criteria for determining money supply
Thapase Reply
who we can define macroeconomics in one line
Muhammad
Aggregate demand
Mohammed
C=k100 +9y and i=k50.calculate the equilibrium level of output
Mercy Reply
Hi
Isiaka
Hi
Geli
hy
Man
👋
Bahunda
hy how are you?
Man
ys
Amisha
how are you guys
Sekou
f9 guys
Amisha
how are you guys
Sekou
ys am also fine
Amisha
fine and you guys
Geli
from Nepal
Amisha
nawalparasi district from belatari
Amisha
nd u
Amisha
I am Camara from Guinea west Africa... happy to meet you guys here
Sekou
ma management ho
Amisha
ahile becheclor ho
Amisha
hjr ktm bta ho ani k kaam grnu hunxa tw
Amisha
belatari
Amisha
1st year ho
Amisha
nd u
Amisha
ahh
Amisha
kaha biratnagar
Amisha
ys
Amisha
kina k vo
Amisha
money as unit of account means what?
Kalombe
A unit of account is something that can be used to value goods and services and make calculations
Jim
all of you please speak in English I can't understand you're language
Muhammad
I want to know how can we define macroeconomics in one line
Muhammad
it must be .9 or 0.9 no Mpc is greater than 1 Y=100+.9Y+50 Y-.9Y=150 0.1Y/0.1=150/0.1 Y=1500
Kalombe
Mercy is it clear?😋
Kalombe
hi can someone help me on this question If a negative shocks shifts the IS curve to the left, what type of policy do you suggest so as to stabilize the level of output? discuss your answer using appropriate graph.
Galge Reply
if interest rate is increased this will will reduce the level of income shifting the curve to the left ◀️
Kalombe
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
<< Chapter < Page Page > Chapter >>
Practice Key Terms 3

Read also:

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, College physics for ap® courses. OpenStax CNX. Nov 04, 2016 Download for free at https://legacy.cnx.org/content/col11844/1.14
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'College physics for ap® courses' conversation and receive update notifications?

Ask