<< Chapter < Page Chapter >> Page >

Calculating helicopter energies

A typical small rescue helicopter, similar to the one in [link] , has four blades, each is 4.00 m long and has a mass of 50.0 kg. The blades can be approximated as thin rods that rotate about one end of an axis perpendicular to their length. The helicopter has a total loaded mass of 1000 kg. (a) Calculate the rotational kinetic energy in the blades when they rotate at 300 rpm. (b) Calculate the translational kinetic energy of the helicopter when it flies at 20.0 m/s, and compare it with the rotational energy in the blades. (c) To what height could the helicopter be raised if all of the rotational kinetic energy could be used to lift it?

Strategy

Rotational and translational kinetic energies can be calculated from their definitions. The last part of the problem relates to the idea that energy can change form, in this case from rotational kinetic energy to gravitational potential energy.

Solution for (a)

The rotational kinetic energy is

KE rot = 1 2 2 . size 12{"KE" rSub { size 8{"rot"} } = { {1} over {2} } Iω rSup { size 8{2} } } {}

We must convert the angular velocity to radians per second and calculate the moment of inertia before we can find KE rot . The angular velocity ω size 12{ω} {} is

ω = 300 rev 1.00 min 2π rad 1 rev 1.00 min 60.0 s = 31.4 rad s . size 12{ω= { {"300"" rev"} over {1 "." "00 min"} } cdot { {2π" rad"} over {"1 rev"} } cdot { {1 "." "00"" min"} over {"60" "." 0" s"} } ="31" "." 4 { {"rad"} over {s} } } {}

The moment of inertia of one blade will be that of a thin rod rotated about its end, found in [link] . The total I size 12{I} {} is four times this moment of inertia, because there are four blades. Thus,

I = 4 Mℓ 2 3 = 4 × 50.0 kg 4.00 m 2 3 = 1067 kg m 2 . size 12{I=4 { {Mℓ rSup { size 8{2} } } over {3} } =4 times { { left ("50" "." 0" kg" right ) left (4 "." "00"" m" right ) rSup { size 8{2} } } over {3} } ="1067"" kg" cdot m rSup { size 8{2} } } {}

Entering ω size 12{ω} {} and I size 12{I} {} into the expression for rotational kinetic energy gives

KE rot = 0.5 ( 1067 kg m 2 ) 31.4 rad/s 2 = 5.26 × 10 5 J alignl { stack { size 12{"KE" rSub { size 8{"rot"} } =0 "." 5 left ("1067"" kg" cdot m rSup { size 8{2} } right ) left ("31" "." 4" rad/s" right ) rSup { size 8{2} } } {} #" "=5 "." "26" times "10" rSup { size 8{5} } " J" {} } } {}

Solution for (b)

Translational kinetic energy was defined in Uniform Circular Motion and Gravitation . Entering the given values of mass and velocity, we obtain

KE trans = 1 2 mv 2 = 0.5 1000 kg 20.0 m/s 2 = 2 . 00 × 10 5 J . size 12{"KE" rSub { size 8{"trans"} } = { {1} over {2} } ital "mv" rSup { size 8{2} } =0 "." 5 left ("1000"" kg" right ) left ("20" "." 0" m/s" right ) rSup { size 8{2} } =2 "." "00" times "10" rSup { size 8{5} } " J"} {}

To compare kinetic energies, we take the ratio of translational kinetic energy to rotational kinetic energy. This ratio is

2 . 00 × 10 5 J 5 . 26 × 10 5 J = 0.380 . size 12{ { {2 "." "00" times "10" rSup { size 8{5} } " J"} over {5 "." "26" times "10" rSup { size 8{5} } " J"} } =0 "." "380"} {}

Solution for (c)

At the maximum height, all rotational kinetic energy will have been converted to gravitational energy. To find this height, we equate those two energies:

KE rot = PE grav size 12{"KE" rSub { size 8{"rot"} } ="PE" rSub { size 8{"grav"} } } {}

or

1 2 2 = mgh . size 12{ { {1} over {2} } Iω rSup { size 8{2} } = ital "mgh"} {}

We now solve for h size 12{h} {} and substitute known values into the resulting equation

h = 1 2 2 mg = 5.26 × 10 5 J 1000 kg 9.80 m/s 2 = 53.7 m . size 12{h= { { { size 8{1} } wideslash { size 8{2} } Iω rSup { size 8{2} } } over { ital "mg"} } = { {5 "." "26" times "10" rSup { size 8{5} } " J"} over { left ("1000"" kg" right ) left (9 "." "80"" m/s" rSup { size 8{2} } right )} } ="53" "." 7" m"} {}

Discussion

The ratio of translational energy to rotational kinetic energy is only 0.380. This ratio tells us that most of the kinetic energy of the helicopter is in its spinning blades—something you probably would not suspect. The 53.7 m height to which the helicopter could be raised with the rotational kinetic energy is also impressive, again emphasizing the amount of rotational kinetic energy in the blades.

The given figure here shows a helicopter from the Auckland Westpac Rescue Helicopter Service over a sea. A rescue diver is shown holding the iron stand bar at the bottom of the helicopter, clutching a person. In the other image just above this, the blades of the helicopter are shown with their anti-clockwise rotation direction shown with an arrow and the length of one blade is given as four meters.
The first image shows how helicopters store large amounts of rotational kinetic energy in their blades. This energy must be put into the blades before takeoff and maintained until the end of the flight. The engines do not have enough power to simultaneously provide lift and put significant rotational energy into the blades. The second image shows a helicopter from the Auckland Westpac Rescue Helicopter Service. Over 50,000 lives have been saved since its operations beginning in 1973. Here, a water rescue operation is shown. (credit: 111 Emergency, Flickr)

Questions & Answers

how do you get the 2/50
Abba Reply
number of sport play by 50 student construct discrete data
Aminu Reply
width of the frangebany leaves on how to write a introduction
Theresa Reply
Solve the mean of variance
Veronica Reply
Step 1: Find the mean. To find the mean, add up all the scores, then divide them by the number of scores. ... Step 2: Find each score's deviation from the mean. ... Step 3: Square each deviation from the mean. ... Step 4: Find the sum of squares. ... Step 5: Divide the sum of squares by n – 1 or N.
kenneth
what is error
Yakuba Reply
Is mistake done to something
Vutshila
Hy
anas
hy
What is the life teble
anas
hy
Jibrin
statistics is the analyzing of data
Tajudeen Reply
what is statics?
Zelalem Reply
how do you calculate mean
Gloria Reply
diveving the sum if all values
Shaynaynay
let A1,A2 and A3 events be independent,show that (A1)^c, (A2)^c and (A3)^c are independent?
Fisaye Reply
what is statistics
Akhisani Reply
data collected all over the world
Shaynaynay
construct a less than and more than table
Imad Reply
The sample of 16 students is taken. The average age in the sample was 22 years with astandard deviation of 6 years. Construct a 95% confidence interval for the age of the population.
Aschalew Reply
Bhartdarshan' is an internet-based travel agency wherein customer can see videos of the cities they plant to visit. The number of hits daily is a normally distributed random variable with a mean of 10,000 and a standard deviation of 2,400 a. what is the probability of getting more than 12,000 hits? b. what is the probability of getting fewer than 9,000 hits?
Akshay Reply
Bhartdarshan'is an internet-based travel agency wherein customer can see videos of the cities they plan to visit. The number of hits daily is a normally distributed random variable with a mean of 10,000 and a standard deviation of 2,400. a. What is the probability of getting more than 12,000 hits
Akshay
1
Bright
Sorry i want to learn more about this question
Bright
Someone help
Bright
a= 0.20233 b=0.3384
Sufiyan
a
Shaynaynay
How do I interpret level of significance?
Mohd Reply
It depends on your business problem or in Machine Learning you could use ROC- AUC cruve to decide the threshold value
Shivam
how skewness and kurtosis are used in statistics
Owen Reply
yes what is it
Taneeya
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 2

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, College physics for ap® courses. OpenStax CNX. Nov 04, 2016 Download for free at https://legacy.cnx.org/content/col11844/1.14
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'College physics for ap® courses' conversation and receive update notifications?

Ask