<< Chapter < Page Chapter >> Page >
  • Define pressure.
  • Explain the relationship between pressure and force.
  • Calculate force given pressure and area.

You have no doubt heard the word pressure    being used in relation to blood (high or low blood pressure) and in relation to the weather (high- and low-pressure weather systems). These are only two of many examples of pressures in fluids. Pressure P size 12{P} {} is defined as

P = F A size 12{P= { {F} over {A} } } {}

where F size 12{P} {} is a force applied to an area A size 12{P} {} that is perpendicular to the force.

Pressure

Pressure is defined as the force divided by the area perpendicular to the force over which the force is applied, or

P = F A . size 12{P= { {F} over {A} } } {}

A given force can have a significantly different effect depending on the area over which the force is exerted, as shown in [link] . The SI unit for pressure is the pascal , where

1 Pa = 1 N/m 2 . size 12{1`"Pa"=1`"Nm" rSup { size 8{2} } } {}

In addition to the pascal, there are many other units for pressure that are in common use. In meteorology, atmospheric pressure is often described in units of millibar (mb), where

100 mb = 1 × 10 5 Pa  . size 12{"100"`"mb"=1 times "10" rSup { size 8{5} } `"Pa"} {}

Pounds per square inch lb/in 2 or psi size 12{ left ("lb/in" rSup { size 8{2} } `"or"``"psi" right )} {} is still sometimes used as a measure of tire pressure, and millimeters of mercury (mm Hg) is still often used in the measurement of blood pressure. Pressure is defined for all states of matter but is particularly important when discussing fluids.

In figure a, the person is poked with a finger exerting a small pressure due to the large area of contact and, in b, he is poked with a syringe exerting a large pressure due to the small area of contact.
(a) While the person being poked with the finger might be irritated, the force has little lasting effect. (b) In contrast, the same force applied to an area the size of the sharp end of a needle is great enough to break the skin.

Calculating force exerted by the air: what force does a pressure exert?

An astronaut is working outside the International Space Station where the atmospheric pressure is essentially zero. The pressure gauge on her air tank reads 6 . 90 × 10 6 Pa size 12{6 "." "90" times "10" rSup { size 8{6} } `"Pa"} {} . What force does the air inside the tank exert on the flat end of the cylindrical tank, a disk 0.150 m in diameter?

Strategy

We can find the force exerted from the definition of pressure given in P = F A size 12{P= { {F} over {A} } } {} , provided we can find the area A size 12{A} {} acted upon.

Solution

By rearranging the definition of pressure to solve for force, we see that

F = PA . size 12{F= ital "PA"} {}

Here, the pressure P size 12{P} {} is given, as is the area of the end of the cylinder A size 12{A} {} , given by A = πr 2 size 12{A=πr rSup { size 8{2} } } {} . Thus,

F = 6.90 × 10 6 N/m 2 3.14 0.0750 m 2 = 1.22 × 10 5 N. alignl { stack { size 12{F= left (6 "." "90" times "10" rSup { size 8{6} } `"N/m" rSup { size 8{2} } right ) left (3 "." "14" right ) left (0 "." "0750"`m right ) rSup { size 8{2} } } {} #=1 "." "22" times "10" rSup { size 8{5} } `N "." {} } } {}

Discussion

Wow! No wonder the tank must be strong. Since we found F = PA size 12{F= ital "PA"} {} , we see that the force exerted by a pressure is directly proportional to the area acted upon as well as the pressure itself.

Got questions? Get instant answers now!

The force exerted on the end of the tank is perpendicular to its inside surface. This direction is because the force is exerted by a static or stationary fluid. We have already seen that fluids cannot withstand shearing (sideways) forces; they cannot exert shearing forces, either. Fluid pressure has no direction, being a scalar quantity. The forces due to pressure have well-defined directions: they are always exerted perpendicular to any surface. (See the tire in [link] , for example.) Finally, note that pressure is exerted on all surfaces. Swimmers, as well as the tire, feel pressure on all sides. (See [link] .)

The forces inside a tire are shown by arrow lines. An inset shows an enlarged view of the valve in the tire. Air pressure in the tire keeps the valve closed.
Pressure inside this tire exerts forces perpendicular to all surfaces it contacts. The arrows give representative directions and magnitudes of the forces exerted at various points. Note that static fluids do not exert shearing forces.
A man swimming underwater has many arrows pointing toward him to represent the directions and magnitudes of the forces exerted on him at various points.
Pressure is exerted on all sides of this swimmer, since the water would flow into the space he occupies if he were not there. The arrows represent the directions and magnitudes of the forces exerted at various points on the swimmer. Note that the forces are larger underneath, due to greater depth, giving a net upward or buoyant force that is balanced by the weight of the swimmer.

Phet explorations: gas properties

Pump gas molecules to a box and see what happens as you change the volume, add or remove heat, change gravity, and more. Measure the temperature and pressure, and discover how the properties of the gas vary in relation to each other.

Gas Properties

Section summary

  • Pressure is the force per unit perpendicular area over which the force is applied. In equation form, pressure is defined as
    P = F A . size 12{P= { {F} over {A} } "." } {}
  • The SI unit of pressure is pascal and 1 Pa = 1 N/m 2 size 12{1`"Pa"=1`"N/m" rSup { size 8{2} } } {} .

Conceptual questions

How is pressure related to the sharpness of a knife and its ability to cut?

Got questions? Get instant answers now!

Why does a dull hypodermic needle hurt more than a sharp one?

Got questions? Get instant answers now!

The outward force on one end of an air tank was calculated in [link] . How is this force balanced? (The tank does not accelerate, so the force must be balanced.)

Got questions? Get instant answers now!

Why is force exerted by static fluids always perpendicular to a surface?

Got questions? Get instant answers now!

In a remote location near the North Pole, an iceberg floats in a lake. Next to the lake (assume it is not frozen) sits a comparably sized glacier sitting on land. If both chunks of ice should melt due to rising global temperatures (and the melted ice all goes into the lake), which ice chunk would give the greatest increase in the level of the lake water, if any?

Got questions? Get instant answers now!

How do jogging on soft ground and wearing padded shoes reduce the pressures to which the feet and legs are subjected?

Got questions? Get instant answers now!

Toe dancing (as in ballet) is much harder on toes than normal dancing or walking. Explain in terms of pressure.

Got questions? Get instant answers now!

How do you convert pressure units like millimeters of mercury, centimeters of water, and inches of mercury into units like newtons per meter squared without resorting to a table of pressure conversion factors?

Got questions? Get instant answers now!

Problems&Exercises

As a woman walks, her entire weight is momentarily placed on one heel of her high-heeled shoes. Calculate the pressure exerted on the floor by the heel if it has an area of 1 . 50 cm 2 size 12{1 "." "50"`"cm" rSup { size 8{2} } } {} and the woman’s mass is 55.0 kg. Express the pressure in Pa. (In the early days of commercial flight, women were not allowed to wear high-heeled shoes because aircraft floors were too thin to withstand such large pressures.)

3.59 × 10 6 Pa ; or 521 lb/in 2 size 12{"521"`"lb/in" rSup { size 8{2} } } {}

Got questions? Get instant answers now!

The pressure exerted by a phonograph needle on a record is surprisingly large. If the equivalent of 1.00 g is supported by a needle, the tip of which is a circle 0.200 mm in radius, what pressure is exerted on the record in N/m 2 size 12{"N/m" rSup { size 8{2} } } {} ?

Got questions? Get instant answers now!

Nail tips exert tremendous pressures when they are hit by hammers because they exert a large force over a small area. What force must be exerted on a nail with a circular tip of 1.00 mm diameter to create a pressure of 3 . 00 × 10 9 N/m 2 ? (This high pressure is possible because the hammer striking the nail is brought to rest in such a short distance.)

2.36 × 10 3 N size 12{2 "." "36" times "10" rSup { size 8{3} } `N} {}

Got questions? Get instant answers now!

Questions & Answers

Three charges q_{1}=+3\mu C, q_{2}=+6\mu C and q_{3}=+8\mu C are located at (2,0)m (0,0)m and (0,3) coordinates respectively. Find the magnitude and direction acted upon q_{2} by the two other charges.Draw the correct graphical illustration of the problem above showing the direction of all forces.
Kate Reply
To solve this problem, we need to first find the net force acting on charge q_{2}. The magnitude of the force exerted by q_{1} on q_{2} is given by F=\frac{kq_{1}q_{2}}{r^{2}} where k is the Coulomb constant, q_{1} and q_{2} are the charges of the particles, and r is the distance between them.
Muhammed
What is the direction and net electric force on q_{1}= 5µC located at (0,4)r due to charges q_{2}=7mu located at (0,0)m and q_{3}=3\mu C located at (4,0)m?
Kate Reply
what is the change in momentum of a body?
Eunice Reply
what is a capacitor?
Raymond Reply
Capacitor is a separation of opposite charges using an insulator of very small dimension between them. Capacitor is used for allowing an AC (alternating current) to pass while a DC (direct current) is blocked.
Gautam
A motor travelling at 72km/m on sighting a stop sign applying the breaks such that under constant deaccelerate in the meters of 50 metres what is the magnitude of the accelerate
Maria Reply
please solve
Sharon
8m/s²
Aishat
What is Thermodynamics
Muordit
velocity can be 72 km/h in question. 72 km/h=20 m/s, v^2=2.a.x , 20^2=2.a.50, a=4 m/s^2.
Mehmet
A boat travels due east at a speed of 40meter per seconds across a river flowing due south at 30meter per seconds. what is the resultant speed of the boat
Saheed Reply
50 m/s due south east
Someone
which has a higher temperature, 1cup of boiling water or 1teapot of boiling water which can transfer more heat 1cup of boiling water or 1 teapot of boiling water explain your . answer
Ramon Reply
I believe temperature being an intensive property does not change for any amount of boiling water whereas heat being an extensive property changes with amount/size of the system.
Someone
Scratch that
Someone
temperature for any amount of water to boil at ntp is 100⁰C (it is a state function and and intensive property) and it depends both will give same amount of heat because the surface available for heat transfer is greater in case of the kettle as well as the heat stored in it but if you talk.....
Someone
about the amount of heat stored in the system then in that case since the mass of water in the kettle is greater so more energy is required to raise the temperature b/c more molecules of water are present in the kettle
Someone
definitely of physics
Haryormhidey Reply
how many start and codon
Esrael Reply
what is field
Felix Reply
physics, biology and chemistry this is my Field
ALIYU
field is a region of space under the influence of some physical properties
Collete
what is ogarnic chemistry
WISDOM Reply
determine the slope giving that 3y+ 2x-14=0
WISDOM
Another formula for Acceleration
Belty Reply
a=v/t. a=f/m a
IHUMA
innocent
Adah
pratica A on solution of hydro chloric acid,B is a solution containing 0.5000 mole ofsodium chlorid per dm³,put A in the burret and titrate 20.00 or 25.00cm³ portion of B using melting orange as the indicator. record the deside of your burret tabulate the burret reading and calculate the average volume of acid used?
Nassze Reply
how do lnternal energy measures
Esrael
Two bodies attract each other electrically. Do they both have to be charged? Answer the same question if the bodies repel one another.
JALLAH Reply
No. According to Isac Newtons law. this two bodies maybe you and the wall beside you. Attracting depends on the mass och each body and distance between them.
Dlovan
Are you really asking if two bodies have to be charged to be influenced by Coulombs Law?
Robert
like charges repel while unlike charges atttact
Raymond
What is specific heat capacity
Destiny Reply
Specific heat capacity is a measure of the amount of energy required to raise the temperature of a substance by one degree Celsius (or Kelvin). It is measured in Joules per kilogram per degree Celsius (J/kg°C).
AI-Robot
specific heat capacity is the amount of energy needed to raise the temperature of a substance by one degree Celsius or kelvin
ROKEEB
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 1

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, College physics. OpenStax CNX. Jul 27, 2015 Download for free at http://legacy.cnx.org/content/col11406/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'College physics' conversation and receive update notifications?

Ask