<< Chapter < Page Chapter >> Page >

That is,

N = w = w cos 25º = mg cos 25º . size 12{N=w rSub { size 8{ ortho } } =w"cos""25" rSup { size 8{ circ } } = ital "mg""cos""25" rSup { size 8{ circ } } } {}

Substituting this into our expression for kinetic friction, we get

f k = μ k mg cos 25º , size 12{f rSub { size 8{k} } =μ rSub { size 8{k} } ital "mg""cos""25" rSup { size 8{ circ } } } {}

which can now be solved for the coefficient of kinetic friction μ k size 12{μ rSub { size 8{k} } } {} .

Solution

Solving for μ k size 12{μ rSub { size 8{k} } } {} gives

μ k = f k N = f k w cos 25º = f k mg cos 25º . size 12{μ rSub { size 8{k} } = { {f rSub { size 8{k} } } over {N} } = { {f rSub { size 8{k} } } over {w"cos""25" rSup { size 8{ circ } } } } = { {f rSub { size 8{k} } } over { ital "mg""cos""25" rSup { size 8{ circ } } } } } {}

Substituting known values on the right-hand side of the equation,

μ k = 45.0 N ( 62 kg ) ( 9 . 80 m /s 2 ) ( 0 . 906 ) = 0 . 082 . size 12{μ rSub { size 8{k} } = { {"45" "." 0N} over { \( "60"`"kg" \) \( 9 "." "80"`"m/s" rSup { size 8{2} } \) \( 0 "." "906" \) } } =0 "." "084"} {}

Discussion

This result is a little smaller than the coefficient listed in [link] for waxed wood on snow, but it is still reasonable since values of the coefficients of friction can vary greatly. In situations like this, where an object of mass m slides down a slope that makes an angle θ size 12{θ} {} with the horizontal, friction is given by f k = μ k mg cos θ size 12{f rSub { size 8{k} } =μ rSub { size 8{k} } ital "mg""cos"θ} {} . All objects will slide down a slope with constant acceleration under these circumstances. Proof of this is left for this chapter’s Problems and Exercises.

Take-home experiment

An object will slide down an inclined plane at a constant velocity if the net force on the object is zero. We can use this fact to measure the coefficient of kinetic friction between two objects. As shown in [link] , the kinetic friction on a slope f k = μ k mg cos θ size 12{f rSub { size 8{k} } =μ rSub { size 8{k} } ital "mg""cos"θ} {} . The component of the weight down the slope is equal to mg sin θ size 12{ ital "mg""sin"θ} {} (see the free-body diagram in [link] ). These forces act in opposite directions, so when they have equal magnitude, the acceleration is zero. Writing these out:

f k = Fg x size 12{f rSub { size 8{k} } = ital "Fgx"} {}
μ k mg cos θ = mg sin θ . size 12{μ rSub { size 8{k} } ital "mg""cos"θ= ital "mg""sin"θ} {}

Solving for μ k size 12{μ rSub { size 8{k} } } {} , we find that

μ k = mg sin θ mg cos θ = tan θ . size 12{μ rSub { size 8{k} } = { { ital "mg""sin"θ} over { ital "mg""cos"θ} } ="tan"θ} {}

Put a coin on a book and tilt it until the coin slides at a constant velocity down the book. You might need to tap the book lightly to get the coin to move. Measure the angle of tilt relative to the horizontal and find μ k size 12{μ rSub { size 8{K} } } {} . Note that the coin will not start to slide at all until an angle greater than θ size 12{θ} {} is attained, since the coefficient of static friction is larger than the coefficient of kinetic friction. Discuss how this may affect the value for μ k size 12{μ rSub { size 8{K} } } {} and its uncertainty.

We have discussed that when an object rests on a horizontal surface, there is a normal force supporting it equal in magnitude to its weight. Furthermore, simple friction is always proportional to the normal force.

Making connections: submicroscopic explanations of friction

The simpler aspects of friction dealt with so far are its macroscopic (large-scale) characteristics. Great strides have been made in the atomic-scale explanation of friction during the past several decades. Researchers are finding that the atomic nature of friction seems to have several fundamental characteristics. These characteristics not only explain some of the simpler aspects of friction—they also hold the potential for the development of nearly friction-free environments that could save hundreds of billions of dollars in energy which is currently being converted (unnecessarily) to heat.

[link] illustrates one macroscopic characteristic of friction that is explained by microscopic (small-scale) research. We have noted that friction is proportional to the normal force, but not to the area in contact, a somewhat counterintuitive notion. When two rough surfaces are in contact, the actual contact area is a tiny fraction of the total area since only high spots touch. When a greater normal force is exerted, the actual contact area increases, and it is found that the friction is proportional to this area.

Practice Key Terms 5

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Une: physics for the health professions. OpenStax CNX. Aug 20, 2014 Download for free at http://legacy.cnx.org/content/col11697/1.1
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Une: physics for the health professions' conversation and receive update notifications?

Ask