<< Chapter < Page Chapter >> Page >
This module provides an overview of Hypothesis Testing: Matched or Paired Samples as a part of Collaborative Statistics collection (col10522) by Barbara Illowsky and Susan Dean.
  1. Simple random sampling is used.
  2. Sample sizes are often small.
  3. Two measurements (samples) are drawn from the same pair of individuals or objects.
  4. Differences are calculated from the matched or paired samples.
  5. The differences form the sample that is used for the hypothesis test.
  6. The matched pairs have differences that either come from a population that is normal or the number of differences is sufficiently large so the distribution of the sample mean of differences is approximately normal.

In a hypothesis test for matched or paired samples, subjects are matched in pairs and differences are calculated. The differences are the data. Thepopulation mean for the differences, μ d , is then tested using a Student-t test for a single population mean with n - 1 degrees of freedom where n is the number of differences.

The test statistic (t-score) is:

t = x d ¯ μ d ( s d n )

Matched or paired samples

A study was conducted to investigate the effectiveness of hypnotism in reducing pain. Results forrandomly selected subjects are shown in the table. The "before" value is matched to an "after" value and the differences are calculated. The differences have a normal distribution.

Subject: A B C D E F G H
Before 6.6 6.5 9.0 10.3 11.3 8.1 6.3 11.6
After 6.8 2.4 7.4 8.5 8.1 6.1 3.4 2.0

Are the sensory measurements, on average, lower after hypnotism? Test at a 5% significance level.

Corresponding "before" and "after" values form matched pairs. (Calculate "sfter" - "before").

After Data Before Data Difference
6.8 6.6 0.2
2.4 6.5 -4.1
7.4 9 -1.6
8.5 10.3 -1.8
8.1 11.3 -3.2
6.1 8.1 -2
3.4 6.3 -2.9
2 11.6 -9.6

The data for the test are the differences:{0.2, -4.1, -1.6, -1.8, -3.2, -2, -2.9, -9.6}

The sample mean and sample standard deviation of the differences are: x d = -3.13 and s d = 2.91 Verify these values.

Let μ d be the population mean for the differences. We use the subscript d to denote "differences."

Random Variable: X d = the mean difference of the sensory measurements

H o : μ d 0
There is no improvement. ( μ d is the population mean of the differences.)

H a : μ d < 0
There is improvement. The score should be lower after hypnotism so the difference ought to be negativeto indicate improvement.

Distribution for the test: The distribution is a student-t with df = n - 1 = 8 - 1 = 7 . Use t 7 . (Notice that the test is for a single population mean.)

Calculate the p-value using the Student-t distribution: p-value = 0.0095

Graph:

Normal distribution curve of the average difference of sensory measurements with values of -3.13 and 0. A vertical upward line extends from -3.13 to the curve, and the p-value is indicated in the area to the left of this value.

X d is the random variable for thedifferences.

The sample mean and sample standarddeviation of the differences are:

x d = -3.13

s d = 2.91

Compare α and the p-value: α = 0.05 and p-value = 0.0095 . α > p-value .

Make a decision: Since α > p-value , reject H o .

This means that μ d < 0 and there is improvement.

Conclusion: At a 5% level of significance, from the sample data, there is sufficient evidence to conclude that the sensory measurements, on average, are lower afterhypnotism. Hypnotism appears to be effective in reducing pain.

For the TI-83+ and TI-84 calculators, you can either calculate the differences ahead of time ( after - before ) and put the differences into a list or you can put the after data into a first list and the before data into a second list. Then go to a third list and arrow up to the name. Enter 1st list name - 2nd list name. The calculatorwill do the subtraction and you will have the differences in the third list.
TI-83+ and TI-84: Use your list of differences as the data. Press STAT and arrow over to TESTS . Press 2:T-Test . Arrow over to Data and press ENTER . Arrow down and enter 0 for μ 0 , the name of the list where you put the data, and 1 for Freq:. Arrow down to μ : and arrow over to < μ 0 . Press ENTER . Arrow down to Calculate and press ENTER . The p-value is 0.0094 and the test statistic is -3.04. Do these instructions again exceptarrow to Draw (instead of Calculate ). Press ENTER .
Got questions? Get instant answers now!

A college football coach was interested in whether the college's strength development class increased his players' maximum lift (in pounds) on the benchpress exercise. He asked 4 of his players to participate in a study. The amount of weight they could each lift was recorded before they took the strength developmentclass. After completing the class, the amount of weight they could each lift was again measured. The data are as follows:

Weight (in pounds) Player 1 Player 2 Player 3 Player 4
Amount of weighted lifted prior to the class 205 241 338 368
Amount of weight lifted after the class 295 252 330 360

The coach wants to know if the strength development class makes his players stronger, on average.

Record the differences data. Calculate the differences by subtracting the amount of weight lifted prior to the class from the weight lifted after completing the class. Thedata for the differences are: {90, 11, -8, -8}. The differences have a normal distribution.

Using the differences data, calculate the sample mean and the sample standard deviation.

x d = 21.3 s d = 46.7

Using the difference data, this becomes a test of a single __________ (fill in the blank).

Define the random variable: X d = mean difference in the maximum lift per player.

The distribution for the hypothesis test is t 3 .

H o : μ d 0 H a : μ d > 0

Graph:

Normal distribution curve with values of 0 and 21.3. A vertical upward line extends from 21.3 to the curve and the p-value is indicated in the area to the right of this value.

Calculate the p-value: The p-value is 0.2150

Decision: If the level of significance is 5%, the decision is to not reject the null hypothesis because α < p-value .

What is the conclusion?

means; At a 5% level of significance, from the sample data, there is not sufficient evidence to conclude that the strength development class helped to make the players stronger, on average.

Got questions? Get instant answers now!
Got questions? Get instant answers now!

Seven eighth graders at Kennedy Middle School measured how farthey could push the shot-put with their dominant (writing) hand and their weaker (non-writing) hand. They thought that they could push equal distances with eitherhand. The following data was collected.

Distance (in feet) using Student 1 Student 2 Student 3 Student 4 Student 5 Student 6 Student 7
Dominant Hand 30 26 34 17 19 26 20
Weaker Hand 28 14 27 18 17 26 16

Conduct a hypothesis test to determine whether the mean difference in distances between the children's dominant versus weaker hands is significant.

use a t-test on the difference data. Assume the differences have a normal distribution. The random variable is the mean difference.

The test statistic is 2.18 and the p-value is 0.0716.

What is your conclusion?

H 0 : μ d equals 0; H a : μ d does not equal 0; Do not reject the null; At a 5% significance level, from the sample data, there is not sufficient evidence to conclude that the mean difference in distances between the children's dominant versus weaker hands is significant (there is not sufficient evidence to show that the children could push the shot-put further with their dominant hand). Alpha and the p-value are close so the test is not strong.

Got questions? Get instant answers now!
Got questions? Get instant answers now!

Questions & Answers

Three charges q_{1}=+3\mu C, q_{2}=+6\mu C and q_{3}=+8\mu C are located at (2,0)m (0,0)m and (0,3) coordinates respectively. Find the magnitude and direction acted upon q_{2} by the two other charges.Draw the correct graphical illustration of the problem above showing the direction of all forces.
Kate Reply
To solve this problem, we need to first find the net force acting on charge q_{2}. The magnitude of the force exerted by q_{1} on q_{2} is given by F=\frac{kq_{1}q_{2}}{r^{2}} where k is the Coulomb constant, q_{1} and q_{2} are the charges of the particles, and r is the distance between them.
Muhammed
What is the direction and net electric force on q_{1}= 5µC located at (0,4)r due to charges q_{2}=7mu located at (0,0)m and q_{3}=3\mu C located at (4,0)m?
Kate Reply
what is the change in momentum of a body?
Eunice Reply
what is a capacitor?
Raymond Reply
Capacitor is a separation of opposite charges using an insulator of very small dimension between them. Capacitor is used for allowing an AC (alternating current) to pass while a DC (direct current) is blocked.
Gautam
A motor travelling at 72km/m on sighting a stop sign applying the breaks such that under constant deaccelerate in the meters of 50 metres what is the magnitude of the accelerate
Maria Reply
please solve
Sharon
8m/s²
Aishat
What is Thermodynamics
Muordit
velocity can be 72 km/h in question. 72 km/h=20 m/s, v^2=2.a.x , 20^2=2.a.50, a=4 m/s^2.
Mehmet
A boat travels due east at a speed of 40meter per seconds across a river flowing due south at 30meter per seconds. what is the resultant speed of the boat
Saheed Reply
50 m/s due south east
Someone
which has a higher temperature, 1cup of boiling water or 1teapot of boiling water which can transfer more heat 1cup of boiling water or 1 teapot of boiling water explain your . answer
Ramon Reply
I believe temperature being an intensive property does not change for any amount of boiling water whereas heat being an extensive property changes with amount/size of the system.
Someone
Scratch that
Someone
temperature for any amount of water to boil at ntp is 100⁰C (it is a state function and and intensive property) and it depends both will give same amount of heat because the surface available for heat transfer is greater in case of the kettle as well as the heat stored in it but if you talk.....
Someone
about the amount of heat stored in the system then in that case since the mass of water in the kettle is greater so more energy is required to raise the temperature b/c more molecules of water are present in the kettle
Someone
definitely of physics
Haryormhidey Reply
how many start and codon
Esrael Reply
what is field
Felix Reply
physics, biology and chemistry this is my Field
ALIYU
field is a region of space under the influence of some physical properties
Collete
what is ogarnic chemistry
WISDOM Reply
determine the slope giving that 3y+ 2x-14=0
WISDOM
Another formula for Acceleration
Belty Reply
a=v/t. a=f/m a
IHUMA
innocent
Adah
pratica A on solution of hydro chloric acid,B is a solution containing 0.5000 mole ofsodium chlorid per dm³,put A in the burret and titrate 20.00 or 25.00cm³ portion of B using melting orange as the indicator. record the deside of your burret tabulate the burret reading and calculate the average volume of acid used?
Nassze Reply
how do lnternal energy measures
Esrael
Two bodies attract each other electrically. Do they both have to be charged? Answer the same question if the bodies repel one another.
JALLAH Reply
No. According to Isac Newtons law. this two bodies maybe you and the wall beside you. Attracting depends on the mass och each body and distance between them.
Dlovan
Are you really asking if two bodies have to be charged to be influenced by Coulombs Law?
Robert
like charges repel while unlike charges atttact
Raymond
What is specific heat capacity
Destiny Reply
Specific heat capacity is a measure of the amount of energy required to raise the temperature of a substance by one degree Celsius (or Kelvin). It is measured in Joules per kilogram per degree Celsius (J/kg°C).
AI-Robot
specific heat capacity is the amount of energy needed to raise the temperature of a substance by one degree Celsius or kelvin
ROKEEB
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Collaborative statistics. OpenStax CNX. Jul 03, 2012 Download for free at http://cnx.org/content/col10522/1.40
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Collaborative statistics' conversation and receive update notifications?

Ask