<< Chapter < Page Chapter >> Page >
The motion of the projectile has an arched trajectory due to gravity.

The span of projectile motion in the vertical plane is determined by two factors, namely the speed of projection and angle of projection with respect to horizontal. These two factors together determine (i) how long does the projectile remain in air (time of flight, T) (ii) how far does the projectile go in the horizontal direction (range of projectile, R) and (iii) how high does the projectile reach (maximum height, H).

Further, the trajectory of the projectile is symmetric about a vertical line passing through the point of maximum height if point of projection and point of return fall on the same horizontal surface.

Time of flight, t

We have already determined the time of flight, which is given by :

T = 2 u y g = 2 u sin θ g

This equation was derived in the earlier module Projectile motion with the assumption that both point of projection and point of return of the projectile lie on same horizontal level. It may be also be recalled that the equation of motion in vertical direction was evaluated for the condition that net displacement during the entire motion is zero. Hence, if the points are not on the same level, then above equation will not be valid and must be determined by equation of motion for the individual case with appropriate values.

From the above equation, we see that time of flight depends on initial speed and the angle of projection (θ). We must realize here that the range of θ is 0° ≤ θ ≤ 90°. For this range, sinθ is an increasing function. As such, we can say that a projection closer to vertical direction stays longer in the air for a given initial velocity. As a matter of fact, a vertical projectile for which θ = 90° and sinθ = 1, stays in the air for the maximum period.

If the points of projection and return are on same level and air resistance is neglected, which of the following quantities will enable determination of the total time of flight (T) :

(a) horizontal component of projection velocity

(b) projection speed and angle of projection

(c) vertical component of projection velocity

(d) speed at the highest point

The total time of flight is given by :

T = 2 u y g = 2 u sin θ g

We can see that the total time of flight can be determined if vertical component of the velocity ( u y ) is given. Hence option (c) is correct. The vertical component of the velocity ( u y ) , in turn, is determined by the projection speed (u) and angle of projection ( θ ). Hence option (b) is correct.

Now speed at the highest point is equal to the horizontal component of projection velocity (u cos θ ). We can not, however, determine vertical component (u sin θ ) from this value, unless either "u" or " θ " is also given.

Hence, options (b) and (c) are correct.

Note: We have noticed that time of flight is derived considering vertical motion. Horizontal part of the motion is not considered. Thus, the time of flight (t) at any point during the projectile motion is dependent on vertical component of velocity or vertical part of the motion and is independent of horizontal part of the motion.

Got questions? Get instant answers now!

Questions & Answers

what is biology
Hajah Reply
the study of living organisms and their interactions with one another and their environments
AI-Robot
what is biology
Victoria Reply
HOW CAN MAN ORGAN FUNCTION
Alfred Reply
the diagram of the digestive system
Assiatu Reply
allimentary cannel
Ogenrwot
How does twins formed
William Reply
They formed in two ways first when one sperm and one egg are splited by mitosis or two sperm and two eggs join together
Oluwatobi
what is genetics
Josephine Reply
Genetics is the study of heredity
Misack
how does twins formed?
Misack
What is manual
Hassan Reply
discuss biological phenomenon and provide pieces of evidence to show that it was responsible for the formation of eukaryotic organelles
Joseph Reply
what is biology
Yousuf Reply
the study of living organisms and their interactions with one another and their environment.
Wine
discuss the biological phenomenon and provide pieces of evidence to show that it was responsible for the formation of eukaryotic organelles in an essay form
Joseph Reply
what is the blood cells
Shaker Reply
list any five characteristics of the blood cells
Shaker
lack electricity and its more savely than electronic microscope because its naturally by using of light
Abdullahi Reply
advantage of electronic microscope is easily and clearly while disadvantage is dangerous because its electronic. advantage of light microscope is savely and naturally by sun while disadvantage is not easily,means its not sharp and not clear
Abdullahi
cell theory state that every organisms composed of one or more cell,cell is the basic unit of life
Abdullahi
is like gone fail us
DENG
cells is the basic structure and functions of all living things
Ramadan
What is classification
ISCONT Reply
is organisms that are similar into groups called tara
Yamosa
in what situation (s) would be the use of a scanning electron microscope be ideal and why?
Kenna Reply
A scanning electron microscope (SEM) is ideal for situations requiring high-resolution imaging of surfaces. It is commonly used in materials science, biology, and geology to examine the topography and composition of samples at a nanoscale level. SEM is particularly useful for studying fine details,
Hilary
cell is the building block of life.
Condoleezza Reply
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Kinematics fundamentals. OpenStax CNX. Sep 28, 2008 Download for free at http://cnx.org/content/col10348/1.29
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Kinematics fundamentals' conversation and receive update notifications?

Ask