<< Chapter < Page Chapter >> Page >

Vapor-liquid phase transition

Consider, then, trying to measure the volume for lower and lower temperatures to follow the graph . To be specific, we take exactly 1.00 mol of butaneC 4 H 10 at 1 atm pressure. As we lower the temperature from 400K to 300K, we observe the expected proportional decrease in the volume from32.8 L to 24.6 L and this proportionality works very well for temperatures just slightly above 272.6 K, where the volume is 22.4 L.However, when we reach 272.6 K, the volume of the butane drops veryabruptly, falling to about 0.097 L at temperatures just slightly below 272.6 K. This is less than one-half of one percent of theprevious volume! The striking change in volume is shown in the graph as a vertical line at 272.6 K.

This dramatic change in physical properties at one temperature is referred to as a phase transition . When cooling butane through the temperature 272.6 K, the butane is abruptly converted at thattemperature from one phase, gas, to another phase, liquid, with very different physical properties. If we reverse the process,starting with liquid butane at 1 atm pressure and temperature below 272.6 K and then heating, we find that the butane remains entirelyliquid for temperatures below 272.6 K and then becomes entirely gas for temperatures above 272.6 K. We refer to the temperature of thephase transition as the boiling point temperature. (We will discuss the phases present at the boiling point, rather than above and below that temperature, in another section .)

We now consider how the phase transition depends on a variety of factors. First, we consider capturing 2.00mol of butane in the cylinder initially, still at 1 atm pressure. The volume of 2.00 mol is twice that of 1.00 mol, by Avogadro's hypothesis . The proportional decrease in the volume of 2.00 mol of gas is shown in [link] along with the previous result for 1.00 mol. Note that the phase transition is observed tooccur at exactly the same temperature, 272.6 K, even though there is double the mass of butane.

Variation of phase transition with pressure

Consider instead then varying the applied pressure. The result for cooling 1.00 molof butane at a constant 2.00 atm pressure is also shown in [link] . We observe the now familiar phase transition with a similar dramatic drop in volume. However, in thiscase, we find that the phase transition occurs at 293.2 K, over 20 K higher than at the lower pressure. Therefore, the temperature ofthe phase transition depends on the pressure applied. We can measure the boiling point temperature of butane as a function ofthe applied pressure, and this result is plotted here .

Boiling point versus pressure

Finally, we consider varying the substance which we trap in the cylinder. In each case, we discover that theboiling point temperature depends on both what the substance is and on the applied pressure, but does not depend on the amount of thesubstance we trap. In [link] , we have also plotted the boiling point as a function of the pressurefor several substances. It is very clear that the boiling points for different substances can be very different from one another,although the variation of the boiling point with pressure looks similar from one substance to the next.

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Concept development studies in chemistry 2012. OpenStax CNX. Aug 16, 2012 Download for free at http://legacy.cnx.org/content/col11444/1.4
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Concept development studies in chemistry 2012' conversation and receive update notifications?

Ask