<< Chapter < Page Chapter >> Page >

Learning objectives

By the end of this section, you will be able to:

  • Describe the history of state legislative term limits
  • Compare the costs and benefits of term limits

Term limits restrict the length of time a member can serve in the state legislature by capping either lifetime service or the number of consecutive terms. The term limits    movement gained momentum in the 1990s, spreading across a wide array of state legislative institutions. Today, fifteen states have imposed term limits on their state house and state senate members. On the other hand, six states, one as recently as 2004, have repealed the term limits imposed on them by the electorate, through either judicial action in the state Supreme Courts or through legislative action in the state legislature.

National Conference of State Legislatures. 13 March 2015. “The Term-Limited States,” http://www.ncsl.org/research/about-state-legislatures/chart-of-term-limits-states.aspx.

The basics of term limits

Under consecutive term limits    , a member can serve for only a specified period of time in either the state house or the state senate, most commonly eight years. To try to regain a seat in the legislature once the limit has been met, the member will have to wait to run for office again. If the member succeeds, the clock will reset and the legislator may once again serve up to the limit set by the state. In states with a lifetime ban    , such as Oklahoma, members can serve only one time for the number of years allotted, and they are not permitted to run for office again ( [link] ).

See note 65.

A graph titled “Term Limits by State”. The x-axis is labeled “State” and the y-axis is labeled “Years”. The graph has a legend with four categories marked “House”, “Senate,” “Total,” and “Lifetime Ban”. From left to right on the x-axis: “MI” has a ban of 6 years lifetime in the house, and 8 years total lifetime in the senate; “NE” has a ban of 8 years total; “AZ” has a ban of 8 years in the house, and 8 years in the senate; “CO” has a ban of 8 years in the house, and 8 years in the senate; “FL” has a ban of 8 years in the house, and 8 years in the senate; “ME” has a ban of 8 years in the house, and 8 years in the senate; “MT” has a ban of 8 years in the house, and 8 years in the senate; “OH” has a ban of 8 years in the house, and 8 years in the senate; “SD” has a ban of 8 years in the house, and 8 years in the senate; “MO” has a ban of 8 years in the house, and 8 years total lifetime in the senate; “CA” has a ban of 12 years lifetime; “OK” has a ban of 12 years lifetime; “LA” has a ban of 12 years in the house, and 12 years in the senate; “NV” has a ban of 12 years in the house, and 12 years total lifetime in the senate; “AR” has a ban of 16 years total lifetime.
Fifteen states currently have some form of term limits. This chart depicts which states have consecutive term limits or lifetime bans and how long a member can serve under each scenario.

The first term limits were enacted in 1990 in California, Colorado, and Oklahoma. In 1992, eight more states followed suit in one large wave. The last state to enact term limits on legislative members was Nebraska in 2000.

See note 65.
However, term limits did not stay in effect in all these states; many state supreme courts repealed them and declared them unconstitutional for a variety of reasons ( [link] ). For instance, in Massachusetts and Washington, term limits were deemed unconstitutional because they affected candidate qualifications to compete for a given office. The courts ruled that changes to those qualifications could be made only by amending the state constitution, not by voters changing the state law.
National Conference of State Legislatures. “Term Limits and the Courts,” http://www.ncsl.org/research/about-state-legislatures/summaries-of-term-limits-cases.aspx (March 14, 2016).

A timeline chart titled “Term Limit Repeals”. A horizontal line stretches across the chart and is marked with seven points. The first point is labeled “Enacted (1992), WY, OR, WA”. An arrow points from “WA” to the fourth point on the timeline, labeled “Repealed by State Supreme Court (1998)”. An arrow points from “OR” to the fifth point on the timeline, labeled “Repealed by State Supreme Court (2002)”. An arrow points from “WA” to the seventh point on the timeline, labeled “Repealed by State Supreme Court (2004)”. The second point is labeled “Enacted (1994), MA, ID, UT”. An arrow points from “MA” to the third point on the timeline, labeled ““Repealed by State Supreme Court (1997)”. An arrow points from “ID” to the fifth point on the timeline, labeled “Repealed by Legislature (2002)”. An arrow points from “UT” to the sixth point on the timeline, labeled “Repealed by Legislature (2003)”.
A number of states have tried to enact term limits on members of the legislature only to see the laws later repealed by the state legislature or ruled unconstitutional by the state supreme court.

Advantages of term limits

In many cases, the movement to institute term limits was initiated by voters and passed through citizen initiatives, which allow citizens to place a proposed law or constitutional amendment on the ballot for a popular vote.

National Conference of State Legislatures. 20 September 2012. “Initiative, Referendum and Recall,” http://www.ncsl.org/research/elections-and-campaigns/initiative-referendum-and-recall-overview.aspx.
Proponents of term limits felt new blood was needed in state legislatures to bring fresh ideas and perspectives to lawmaking. In addition, they hoped term limits would compel turnover among members by shortening the time anyone could serve and by reducing the tendency for elected officials to make legislative service their career. In conjunction with this thinking, some supporters hoped term limits would increase the motivation to make good public policy. If members were less focused on reelection and knew they could not serve more than a certain number of years, perhaps they would get right down to the business of making laws and produce innovative policy within a narrow window of time.
John Carey, Richard Niemi, and Lynda Powell. 2000. Term Limits in State Legislatures . Ann Arbor: University of Michigan Press.

Questions & Answers

what is phylogeny
Odigie Reply
evolutionary history and relationship of an organism or group of organisms
AI-Robot
ok
Deng
what is biology
Hajah Reply
the study of living organisms and their interactions with one another and their environments
AI-Robot
what is biology
Victoria Reply
HOW CAN MAN ORGAN FUNCTION
Alfred Reply
the diagram of the digestive system
Assiatu Reply
allimentary cannel
Ogenrwot
How does twins formed
William Reply
They formed in two ways first when one sperm and one egg are splited by mitosis or two sperm and two eggs join together
Oluwatobi
what is genetics
Josephine Reply
Genetics is the study of heredity
Misack
how does twins formed?
Misack
What is manual
Hassan Reply
discuss biological phenomenon and provide pieces of evidence to show that it was responsible for the formation of eukaryotic organelles
Joseph Reply
what is biology
Yousuf Reply
the study of living organisms and their interactions with one another and their environment.
Wine
discuss the biological phenomenon and provide pieces of evidence to show that it was responsible for the formation of eukaryotic organelles in an essay form
Joseph Reply
what is the blood cells
Shaker Reply
list any five characteristics of the blood cells
Shaker
lack electricity and its more savely than electronic microscope because its naturally by using of light
Abdullahi Reply
advantage of electronic microscope is easily and clearly while disadvantage is dangerous because its electronic. advantage of light microscope is savely and naturally by sun while disadvantage is not easily,means its not sharp and not clear
Abdullahi
cell theory state that every organisms composed of one or more cell,cell is the basic unit of life
Abdullahi
is like gone fail us
DENG
cells is the basic structure and functions of all living things
Ramadan
What is classification
ISCONT Reply
is organisms that are similar into groups called tara
Yamosa
in what situation (s) would be the use of a scanning electron microscope be ideal and why?
Kenna Reply
A scanning electron microscope (SEM) is ideal for situations requiring high-resolution imaging of surfaces. It is commonly used in materials science, biology, and geology to examine the topography and composition of samples at a nanoscale level. SEM is particularly useful for studying fine details,
Hilary
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, American government. OpenStax CNX. Dec 05, 2016 Download for free at http://cnx.org/content/col11995/1.15
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'American government' conversation and receive update notifications?

Ask