<< Chapter < Page Chapter >> Page >

h = ( x , y ) H τ size 12{h= \( x,y \) in H rSup { size 8{τ} } } {} if R min < ( x x r ) 2 + ( y y r ) 2 < R max size 12{R rSub { size 8{"min"} }<sqrt { \( x - x rSub { size 8{r} } \) rSup { size 8{2} } + \( y - y rSub { size 8{r} } \) rSup { size 8{2} } }<R rSub { size 8{"max"} } } {}

Where we are assuming that the depth of the target is small when compared to its ( x , y ) size 12{ \( x,y \) } {} coordinates, the receiver is located at ( x r , y r ) size 12{ \( x rSub { size 8{r} } ,y rSub { size 8{r} } \) } {} . R min size 12{R rSub { size 8{"min"} } } {} is the range at which the echo is noise, not reverberation limited, and R max size 12{R rSub { size 8{"max"} } } {} is the farthest range of interest. For this problem, h size 12{h} {} is an index into the target range from the sonar.

Sonar receiver model

The sonar transmits the waveform m ( t ) size 12{m \( t \) } {} for each ping. In most sonar transmitters, the transmitted waveform is narrow-band, that is, the waveform bandwidth is much smaller than its center frequency, f size 12{f} {} . This is true because efficient sonar transmitters use resonant mechanical and electrical components to provide maximum electrical to sound power transfer. An approximation therefore is to model the transmitted waveform as an amplitude modulated carrier:

m ( t ) = sin ( ft ) w ( t ) size 12{m \( t \) ="sin" \( 2πital "ft" \) w \( t \) } {} , t = ( 0, T ) size 12{t= \( 0,T \) } {}

We will assume that the target is motionless, so that Doppler effects can be ignored. We will assume that the sonar receiver is a single sensor, with no directionality characteristics. For each target location hypothesis h = ( x , y ) size 12{h= \( x,y \) } {} we know approximately the received echo time series:

g ( t h ) = Bm ( t 2R / c ) size 12{g \( t \lline h \) = ital "Bm" \( t - 2R/c \) } {}

The amplitude B size 12{B} {} is related to the propagation loss out to the target hypothesis location, and the reflection characteristics of the target. The time delay 2R / c size 12{2R/c} {} corresponds to the time it takes for the transmission waveform to reach the target and return to the sonar. R size 12{R} {} is the range to the target and c is the effective speed of sound, when including refraction and boundary reflections.

The received echo is band-limited to approximately the same frequency band as the transmission. The receiver bandwidth may be greater than the transmitted bandwidth due to Doppler frequency shifts, but for the present, we are assuming that the target is not moving. Sonar receivers use heterodyne techniques to reduce the data storage of the ping history. The sonar receiver multiplies the ping history by a carrier signal e j2π ft size 12{e rSup { size 8{ - j2πital "ft"} } } {} to shift the positive frequency part of the received echo closer to DC. The resulting signal is then low pass filtered to eliminate the shifted negative frequency part of the ping history. Since the original ping history was real, the negative frequency part of the signal spectra carries no additional information. The result is a complex signal with a lower bandwidth, but retains all of the echo related information of the original ping history. This heterodyne process can be done in the analog or digital domain.

A target echo passing through the heterodyne part of the sonar receiver becomes:

r ( t h ) = Ae w ( t 2R / c ) size 12{r \( t \lline h \) = ital "Ae" rSup { size 8{jθ} } w \( t - 2R/c \) } {}

The phase shift θ size 12{θ} {} corresponds to the phase shift due to heterodyne operation; the uncertainty in propagation conditions; and the summation of multi-path arrivals with almost the same time delay, etc.

We will assume that the target echo amplitude, Ae size 12{ ital "Ae" rSup { size 8{jθ} } } {} ,is a complex Gaussian random variable with zero mean and with standard deviation σ 2 ( h ) . size 12{σrSup { size 8{2} } \( h \) "." } {} We are modeling the echo as having the same waveform as the transmission, but with an uncertain phase and amplitude. This is assuming that the target echo amplitude obeys Swerling target type I statistics with unknown phase.

Questions & Answers

Three charges q_{1}=+3\mu C, q_{2}=+6\mu C and q_{3}=+8\mu C are located at (2,0)m (0,0)m and (0,3) coordinates respectively. Find the magnitude and direction acted upon q_{2} by the two other charges.Draw the correct graphical illustration of the problem above showing the direction of all forces.
Kate Reply
To solve this problem, we need to first find the net force acting on charge q_{2}. The magnitude of the force exerted by q_{1} on q_{2} is given by F=\frac{kq_{1}q_{2}}{r^{2}} where k is the Coulomb constant, q_{1} and q_{2} are the charges of the particles, and r is the distance between them.
Muhammed
What is the direction and net electric force on q_{1}= 5µC located at (0,4)r due to charges q_{2}=7mu located at (0,0)m and q_{3}=3\mu C located at (4,0)m?
Kate Reply
what is the change in momentum of a body?
Eunice Reply
what is a capacitor?
Raymond Reply
Capacitor is a separation of opposite charges using an insulator of very small dimension between them. Capacitor is used for allowing an AC (alternating current) to pass while a DC (direct current) is blocked.
Gautam
A motor travelling at 72km/m on sighting a stop sign applying the breaks such that under constant deaccelerate in the meters of 50 metres what is the magnitude of the accelerate
Maria Reply
please solve
Sharon
8m/s²
Aishat
What is Thermodynamics
Muordit
velocity can be 72 km/h in question. 72 km/h=20 m/s, v^2=2.a.x , 20^2=2.a.50, a=4 m/s^2.
Mehmet
A boat travels due east at a speed of 40meter per seconds across a river flowing due south at 30meter per seconds. what is the resultant speed of the boat
Saheed Reply
50 m/s due south east
Someone
which has a higher temperature, 1cup of boiling water or 1teapot of boiling water which can transfer more heat 1cup of boiling water or 1 teapot of boiling water explain your . answer
Ramon Reply
I believe temperature being an intensive property does not change for any amount of boiling water whereas heat being an extensive property changes with amount/size of the system.
Someone
Scratch that
Someone
temperature for any amount of water to boil at ntp is 100⁰C (it is a state function and and intensive property) and it depends both will give same amount of heat because the surface available for heat transfer is greater in case of the kettle as well as the heat stored in it but if you talk.....
Someone
about the amount of heat stored in the system then in that case since the mass of water in the kettle is greater so more energy is required to raise the temperature b/c more molecules of water are present in the kettle
Someone
definitely of physics
Haryormhidey Reply
how many start and codon
Esrael Reply
what is field
Felix Reply
physics, biology and chemistry this is my Field
ALIYU
field is a region of space under the influence of some physical properties
Collete
what is ogarnic chemistry
WISDOM Reply
determine the slope giving that 3y+ 2x-14=0
WISDOM
Another formula for Acceleration
Belty Reply
a=v/t. a=f/m a
IHUMA
innocent
Adah
pratica A on solution of hydro chloric acid,B is a solution containing 0.5000 mole ofsodium chlorid per dm³,put A in the burret and titrate 20.00 or 25.00cm³ portion of B using melting orange as the indicator. record the deside of your burret tabulate the burret reading and calculate the average volume of acid used?
Nassze Reply
how do lnternal energy measures
Esrael
Two bodies attract each other electrically. Do they both have to be charged? Answer the same question if the bodies repel one another.
JALLAH Reply
No. According to Isac Newtons law. this two bodies maybe you and the wall beside you. Attracting depends on the mass och each body and distance between them.
Dlovan
Are you really asking if two bodies have to be charged to be influenced by Coulombs Law?
Robert
like charges repel while unlike charges atttact
Raymond
What is specific heat capacity
Destiny Reply
Specific heat capacity is a measure of the amount of energy required to raise the temperature of a substance by one degree Celsius (or Kelvin). It is measured in Joules per kilogram per degree Celsius (J/kg°C).
AI-Robot
specific heat capacity is the amount of energy needed to raise the temperature of a substance by one degree Celsius or kelvin
ROKEEB
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Signal and information processing for sonar. OpenStax CNX. Dec 04, 2007 Download for free at http://cnx.org/content/col10422/1.5
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Signal and information processing for sonar' conversation and receive update notifications?

Ask