| << Chapter < Page | Chapter >> Page > |
The limit state of yielding must be considered in tension members to prevent failure from deformation. "To prevent excessivedeformation, initiated by yielding, the load on the gross section must be small enough that the stress on the gross section is lessthan the yield stress ."
Here the design strength of the tension members is where:
Notification Switch
Would you like to follow the 'Steel design (civi 306)' conversation and receive update notifications?
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|