# 6.1 Continuous time fourier series (ctfs)

 Page 1 / 1
This module describes the continuous time Fourier Series (CTFS). It is based on the following modules:Fourier Series: Eigenfunction Approach at http://cnx.org/content/m10496/latest/ by Justin Romberg, Derivation of Fourier Coefficients Equation at http://cnx.org/content/m10733/latest/ by Michael Haag,Fourier Series and LTI Systems at http://cnx.org/content/m10752/latest/ by Justin Romberg, and Fourier Series Wrap-Up at http://cnx.org/content/m10749/latest/ by Michael Haag and Justin Romberg.

## Introduction

In this module, we will derive an expansion for continuous-time, periodic functions, and in doing so, derive the Continuous Time Fourier Series (CTFS).

Since complex exponentials are eigenfunctions of linear time-invariant (LTI) systems , calculating the output of an LTI system $ℋ$ given $e^{st}$ as an input amounts to simple multiplication, where $H(s)\in \mathbb{C}$ is the eigenvalue corresponding to s. As shown in the figure, a simple exponential input would yield the output

$y(t)=H(s)e^{st}$

Using this and the fact that $ℋ$ is linear, calculating $y(t)$ for combinations of complex exponentials is also straightforward.

${c}_{1}e^{{s}_{1}t}+{c}_{2}e^{{s}_{2}t}\to {c}_{1}H({s}_{1})e^{{s}_{1}t}+{c}_{2}H({s}_{2})e^{{s}_{2}t}$ $\sum {c}_{n}e^{{s}_{n}t}\to \sum {c}_{n}H({s}_{n})e^{{s}_{n}t}$

The action of $H$ on an input such as those in the two equations above is easy to explain. $ℋ$ independently scales each exponential component $e^{{s}_{n}t}$ by a different complex number $H({s}_{n})\in \mathbb{C}$ . As such, if we can write a function $f(t)$ as a combination of complex exponentials it allows us to easily calculate the output of a system.

## Fourier series synthesis

Joseph Fourier demonstrated that an arbitrary $f(t)$ can be written as a linear combination of harmonic complex sinusoids

$f(t)=\sum$ c n j ω 0 n t
where ${\omega }_{0}=\frac{2\pi }{T}$ is the fundamental frequency. For almost all $f(t)$ of practical interest, there exists ${c}_{n}$ to make [link] true. If $f(t)$ is finite energy ( $f(t)\in L(0, T)^{2}$ ), then the equality in [link] holds in the sense of energy convergence; if $f(t)$ is continuous, then [link] holds pointwise. Also, if $f(t)$ meets some mild conditions (the Dirichlet conditions), then [link] holds pointwise everywhere except at points of discontinuity.

The ${c}_{n}$ - called the Fourier coefficients - tell us "how much" of the sinusoid $e^{j{\omega }_{0}nt}$ is in $f(t)$ . The formula shows $f(t)$ as a sum of complex exponentials, each of which is easily processed by an LTI system (since it is an eigenfunction of every LTI system). Mathematically, it tells us that the set ofcomplex exponentials $\{\forall n, n\in \mathbb{Z}\colon e^{j{\omega }_{0}nt}\}$ form a basis for the space of T-periodic continuous time functions.

We know from Euler's formula that $cos\left(\omega t\right)+sin\left(\omega t\right)=\frac{1-j}{2}{e}^{j\omega t}+\frac{1+j}{2}{e}^{-j\omega t}.$

## Fourier series analysis

Finding the coefficients of the Fourier series expansion involves some algebraic manipulation of the synthesis formula. First of all we will multiply both sides of the equation by $e^{-(j{\omega }_{0}kt)}$ , where $k\in \mathbb{Z}$ .

$f(t)e^{-(j{\omega }_{0}kt)}=\sum$ c n j ω 0 n t j ω 0 k t
Now integrate both sides over a given period, $T$ :
$\int_{0}^{T} f(t)e^{-(j{\omega }_{0}kt)}\,d t=\int_{0}^{T} \sum \,d t$ c n j ω 0 n t j ω 0 k t
On the right-hand side we can switch the summation andintegral and factor the constant out of the integral.
$\int_{0}^{T} f(t)e^{-(j{\omega }_{0}kt)}\,d t=\sum$ c n t T 0 j ω 0 n k t
Now that we have made this seemingly more complicated, let us focus on just the integral, $\int_{0}^{T} e^{j{\omega }_{0}(n-k)t}\,d t$ , on the right-hand side of the above equation. For this integral we will need to consider two cases: $n=k$ and $n\neq k$ . For $n=k$ we will have:
$\forall n, n=k\colon \int_{0}^{T} e^{j{\omega }_{0}(n-k)t}\,d t=T$
For $n\neq k$ , we will have:
$\forall n, n\neq k\colon \int_{0}^{T} e^{j{\omega }_{0}(n-k)t}\,d t=\int_{0}^{T} \cos ({\omega }_{0}(n-k)t)\,d t+j\int_{0}^{T} \sin ({\omega }_{0}(n-k)t)\,d t$
But $\cos ({\omega }_{0}(n-k)t)$ has an integer number of periods, $n-k$ , between $0$ and $T$ . Imagine a graph of the cosine; because it has an integer number of periods, there areequal areas above and below the x-axis of the graph. This statement holds true for $\sin ({\omega }_{0}(n-k)t)$ as well. What this means is
$\int_{0}^{T} \cos ({\omega }_{0}(n-k)t)\,d t=0$
which also holds for the integral involving the sine function. Therefore, we conclude the following about our integral ofinterest:
$\int_{0}^{T} e^{j{\omega }_{0}(n-k)t}\,d t=\begin{cases}T & \text{if n=k}\\ 0 & \text{otherwise}\end{cases}$
Now let us return our attention to our complicated equation, [link] , to see if we can finish finding an equation for our Fourier coefficients. Using thefacts that we have just proven above, we can see that the only time [link] will have a nonzero result is when $k$ and $n$ are equal:
$\forall n, n=k\colon \int_{0}^{T} f(t)e^{-(j{\omega }_{0}nt)}\,d t=T{c}_{n}$
Finally, we have our general equation for the Fourier coefficients:
${c}_{n}=\frac{1}{T}\int_{0}^{T} f(t)e^{-(j{\omega }_{0}nt)}\,d t$

Consider the square wave function given by

$x\left(t\right)=\left\{\begin{array}{cc}1/2& t\le 1/2\\ -1/2& t>1/2\end{array}\right)$

on the unit interval $t\in \mathbb{Z}\left[0,1\right)$ .

$\begin{array}{cc}\hfill {c}_{k}& ={\int }_{0}^{1}x\left(t\right){e}^{-j2\pi kt}dt\hfill \\ & ={\int }_{0}^{1/2}\frac{1}{2}{e}^{-j2\pi kt}dt-{\int }_{1/2}^{1}\frac{1}{2}{e}^{-j2\pi kt}dt\hfill \\ & =\frac{j\left(-,1,+,{e}^{j\pi k}\right)}{2\pi k}\hfill \end{array}$

Thus, the Fourier coefficients of this function found using the Fourier series analysis formula are

${c}_{k}=\left\{\begin{array}{cc}-j/\pi k& \mathrm{k}\mathrm{odd}\\ 0& \mathrm{k}\mathrm{even}\end{array}\right).$

## Fourier series summary

Because complex exponentials are eigenfunctions of LTI systems, it is often useful to represent signals using a set of complex exponentials as a basis. The continuous time Fourier series synthesis formula expresses a continuous time, periodic function as the sum of continuous time, discrete frequency complex exponentials.

$f(t)=\sum$ c n j ω 0 n t
The continuous time Fourier series analysis formula gives the coefficients of the Fourier series expansion.
${c}_{n}=\frac{1}{T}\int_{0}^{T} f(t)e^{-(j{\omega }_{0}nt)}\,d t$
In both of these equations ${\omega }_{0}=\frac{2\pi }{T}$ is the fundamental frequency.

what does nano mean?
nano basically means 10^(-9). nanometer is a unit to measure length.
Bharti
do you think it's worthwhile in the long term to study the effects and possibilities of nanotechnology on viral treatment?
absolutely yes
Daniel
how to know photocatalytic properties of tio2 nanoparticles...what to do now
it is a goid question and i want to know the answer as well
Maciej
Abigail
for teaching engĺish at school how nano technology help us
Anassong
Do somebody tell me a best nano engineering book for beginners?
what is fullerene does it is used to make bukky balls
are you nano engineer ?
s.
fullerene is a bucky ball aka Carbon 60 molecule. It was name by the architect Fuller. He design the geodesic dome. it resembles a soccer ball.
Tarell
what is the actual application of fullerenes nowadays?
Damian
That is a great question Damian. best way to answer that question is to Google it. there are hundreds of applications for buck minister fullerenes, from medical to aerospace. you can also find plenty of research papers that will give you great detail on the potential applications of fullerenes.
Tarell
what is the Synthesis, properties,and applications of carbon nano chemistry
Mostly, they use nano carbon for electronics and for materials to be strengthened.
Virgil
is Bucky paper clear?
CYNTHIA
so some one know about replacing silicon atom with phosphorous in semiconductors device?
Yeah, it is a pain to say the least. You basically have to heat the substarte up to around 1000 degrees celcius then pass phosphene gas over top of it, which is explosive and toxic by the way, under very low pressure.
Harper
Do you know which machine is used to that process?
s.
how to fabricate graphene ink ?
for screen printed electrodes ?
SUYASH
What is lattice structure?
of graphene you mean?
Ebrahim
or in general
Ebrahim
in general
s.
Graphene has a hexagonal structure
tahir
On having this app for quite a bit time, Haven't realised there's a chat room in it.
Cied
what is biological synthesis of nanoparticles
what's the easiest and fastest way to the synthesize AgNP?
China
Cied
types of nano material
I start with an easy one. carbon nanotubes woven into a long filament like a string
Porter
many many of nanotubes
Porter
what is the k.e before it land
Yasmin
what is the function of carbon nanotubes?
Cesar
I'm interested in nanotube
Uday
what is nanomaterials​ and their applications of sensors.
what is nano technology
what is system testing?
preparation of nanomaterial
how to synthesize TiO2 nanoparticles by chemical methods
Zubear
what's the program
Jordan
?
Jordan
what chemical
Jordan
how did you get the value of 2000N.What calculations are needed to arrive at it
Privacy Information Security Software Version 1.1a
Good
Berger describes sociologists as concerned with
Got questions? Join the online conversation and get instant answers!