<< Chapter < Page Chapter >> Page >

Predicting precipitation

The equation that describes the equilibrium between solid calcium carbonate and its solvated ions is:

CaCO 3 ( s ) Ca 2+ ( a q ) + CO 3 2− ( a q )

We can establish this equilibrium either by adding solid calcium carbonate to water or by mixing a solution that contains calcium ions with a solution that contains carbonate ions. If we add calcium carbonate to water, the solid will dissolve until the concentrations are such that the value of the reaction quotient ( Q = [ Ca 2 + ] [ CO 3 2− ] ) is equal to the solubility product ( K sp = 8.7 × 10 –9 ). If we mix a solution of calcium nitrate, which contains Ca 2+ ions, with a solution of sodium carbonate, which contains CO 3 2− ions, the slightly soluble ionic solid CaCO 3 will precipitate, provided that the concentrations of Ca 2+ and CO 3 2− ions are such that Q is greater than K sp for the mixture. The reaction shifts to the left and the concentrations of the ions are reduced by formation of the solid until the value of Q equals K sp . A saturated solution in equilibrium with the undissolved solid will result. If the concentrations are such that Q is less than K sp , then the solution is not saturated and no precipitate will form.

We can compare numerical values of Q with K sp to predict whether precipitation will occur, as [link] shows. (Note: Since all forms of equilibrium constants are temperature dependent, we will assume a room temperature environment going forward in this chapter unless a different temperature value is explicitly specified.)

Precipitation of mg(oh) 2

The first step in the preparation of magnesium metal is the precipitation of Mg(OH) 2 from sea water by the addition of lime, Ca(OH) 2 , a readily available inexpensive source of OH ion:

Mg(OH) 2 ( s ) Mg 2+ ( a q ) + 2OH ( a q ) K sp = 8.9 × 10 12

The concentration of Mg 2+ ( aq ) in sea water is 0.0537 M . Will Mg(OH) 2 precipitate when enough Ca(OH) 2 is added to give a [OH ] of 0.0010 M ?

Solution

This problem asks whether the reaction:

Mg(OH) 2 ( s ) Mg 2+ ( a q ) + 2OH ( a q )

shifts to the left and forms solid Mg(OH) 2 when [Mg 2+ ] = 0.0537 M and [OH ] = 0.0010 M . The reaction shifts to the left if Q is greater than K sp . Calculation of the reaction quotient under these conditions is shown here:

Q = [ Mg 2+ ] [ OH ] 2 = (0.0537)( 0.0010) 2 = 5.4 × 10 8

Because Q is greater than K sp ( Q = 5.4 × 10 –8 is larger than K sp = 8.9 × 10 –12 ), we can expect the reaction to shift to the left and form solid magnesium hydroxide. Mg(OH) 2 ( s ) forms until the concentrations of magnesium ion and hydroxide ion are reduced sufficiently so that the value of Q is equal to K sp .

Check your learning

Use the solubility product in Appendix J to determine whether CaHPO 4 will precipitate from a solution with [Ca 2+ ] = 0.0001 M and [ HPO 4 2− ] = 0.001 M .

Answer:

No precipitation of CaHPO 4 ; Q = 1 × 10 –7 , which is less than K sp

Got questions? Get instant answers now!

Precipitation of agcl upon mixing solutions

Does silver chloride precipitate when equal volumes of a 2.0 × 10 –4 - M solution of AgNO 3 and a 2.0 × 10 –4 - M solution of NaCl are mixed?

(Note: The solution also contains Na + and NO 3 ions, but when referring to solubility rules, one can see that sodium nitrate is very soluble and cannot form a precipitate.)

Solution

The equation for the equilibrium between solid silver chloride, silver ion, and chloride ion is:

AgCl ( s ) Ag + ( a q ) + Cl ( a q )

The solubility product is 1.6 × 10 –10 (see Appendix J ).

AgCl will precipitate if the reaction quotient calculated from the concentrations in the mixture of AgNO 3 and NaCl is greater than K sp . The volume doubles when we mix equal volumes of AgNO 3 and NaCl solutions, so each concentration is reduced to half its initial value. Consequently, immediately upon mixing, [Ag + ] and [Cl ] are both equal to:

1 2 ( 2.0 × 10 4 ) M = 1.0 × 10 4 M

The reaction quotient, Q , is momentarily greater than K sp for AgCl, so a supersaturated solution is formed:

Q = [ Ag + ] [ Cl ] = (1.0 × 10 4 ) ( 1.0 × 10 4 ) = 1.0 × 10 8 > K sp

Since supersaturated solutions are unstable, AgCl will precipitate from the mixture until the solution returns to equilibrium, with Q equal to K sp .

Check your learning

Will KClO 4 precipitate when 20 mL of a 0.050- M solution of K + is added to 80 mL of a 0.50- M solution of ClO 4 ? (Remember to calculate the new concentration of each ion after mixing the solutions before plugging into the reaction quotient expression.)

Answer:

No, Q = 4.0 × 10 –3 , which is less than K sp = 1.05 × 10 –2

Got questions? Get instant answers now!

Questions & Answers

if three forces F1.f2 .f3 act at a point on a Cartesian plane in the daigram .....so if the question says write down the x and y components ..... I really don't understand
Syamthanda Reply
hey , can you please explain oxidation reaction & redox ?
Boitumelo Reply
hey , can you please explain oxidation reaction and redox ?
Boitumelo
for grade 12 or grade 11?
Sibulele
the value of V1 and V2
Tumelo Reply
advantages of electrons in a circuit
Rethabile Reply
we're do you find electromagnetism past papers
Ntombifuthi
what a normal force
Tholulwazi Reply
it is the force or component of the force that the surface exert on an object incontact with it and which acts perpendicular to the surface
Sihle
what is physics?
Petrus Reply
what is the half reaction of Potassium and chlorine
Anna Reply
how to calculate coefficient of static friction
Lisa Reply
how to calculate static friction
Lisa
How to calculate a current
Tumelo
how to calculate the magnitude of horizontal component of the applied force
Mogano
How to calculate force
Monambi
a structure of a thermocouple used to measure inner temperature
Anna Reply
a fixed gas of a mass is held at standard pressure temperature of 15 degrees Celsius .Calculate the temperature of the gas in Celsius if the pressure is changed to 2×10 to the power 4
Amahle Reply
How is energy being used in bonding?
Raymond Reply
what is acceleration
Syamthanda Reply
a rate of change in velocity of an object whith respect to time
Khuthadzo
how can we find the moment of torque of a circular object
Kidist
Acceleration is a rate of change in velocity.
Justice
t =r×f
Khuthadzo
how to calculate tension by substitution
Precious Reply
hi
Shongi
hi
Leago
use fnet method. how many obects are being calculated ?
Khuthadzo
khuthadzo hii
Hulisani
how to calculate acceleration and tension force
Lungile Reply
you use Fnet equals ma , newtoms second law formula
Masego
please help me with vectors in two dimensions
Mulaudzi Reply
how to calculate normal force
Mulaudzi
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 4

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Chemistry. OpenStax CNX. May 20, 2015 Download for free at http://legacy.cnx.org/content/col11760/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Chemistry' conversation and receive update notifications?

Ask