<< Chapter < Page Chapter >> Page >

Precipitation of silver halides

A solution contains 0.0010 mol of KI and 0.10 mol of KCl per liter. AgNO 3 is gradually added to this solution. Which forms first, solid AgI or solid AgCl?

Solution

The two equilibria involved are:

AgCl ( s ) Ag + ( a q ) + Cl ( a q ) K sp = 1.6 × 10 10
AgI ( s ) Ag + ( a q ) + I ( a q ) K sp = 1.5 × 10 16

If the solution contained about equal concentrations of Cl and I , then the silver salt with the smallest K sp (AgI) would precipitate first. The concentrations are not equal, however, so we should find the [Ag + ] at which AgCl begins to precipitate and the [Ag + ] at which AgI begins to precipitate. The salt that forms at the lower [Ag + ] precipitates first.

For AgI: AgI precipitates when Q equals K sp for AgI (1.5 × 10 –16 ). When [I ] = 0.0010 M :

Q = [ Ag + ] [ I ] = [ Ag + ] (0.0010) = 1.5 × 10 16
[ Ag + ] = 1.8 × 10 10 0.10 = 1.6 × 10 9

AgI begins to precipitate when [Ag + ] is 1.5 × 10 –13 M .

For AgCl: AgCl precipitates when Q equals K sp for AgCl (1.6 × 10 –10 ). When [Cl ] = 0.10 M :

Q sp = [ Ag + ] [ Cl ] = [ Ag + ] (0.10) = 1.6 × 10 10
[ Ag + ] = 1.8 × 10 10 0.10 = 1.6 × 10 9 M

AgCl begins to precipitate when [Ag + ] is 1.6 × 10 –9 M .

AgI begins to precipitate at a lower [Ag + ] than AgCl, so AgI begins to precipitate first.

Check your learning

If silver nitrate solution is added to a solution which is 0.050 M in both Cl and Br ions, at what [Ag + ] would precipitation begin, and what would be the formula of the precipitate?

Answer:

[Ag + ] = 1.0 × 10 –11 M ; AgBr precipitates first

Got questions? Get instant answers now!

Common ion effect

As we saw when we discussed buffer solutions, the hydronium ion concentration of an aqueous solution of acetic acid decreases when the strong electrolyte sodium acetate, NaCH 3 CO 2 , is added. We can explain this effect using Le Châtelier’s principle. The addition of acetate ions causes the equilibrium to shift to the left, decreasing the concentration of H 3 O + to compensate for the increased acetate ion concentration. This increases the concentration of CH 3 CO 2 H:

CH 3 CO 2 H + H 2 O H 3 O + + CH 3 CO 2

Because sodium acetate and acetic acid have the acetate ion in common, the influence on the equilibrium is called the common ion effect    .

The common ion effect can also have a direct effect on solubility equilibria. Suppose we are looking at the reaction where silver iodide is dissolved:

AgI ( s ) Ag + ( a q ) + I ( a q )

If we were to add potassium iodide (KI) to this solution, we would be adding a substance that shares a common ion with silver iodide. Le Châtelier’s principle tells us that when a change is made to a system at equilibrium, the reaction will shift to counteract that change. In this example, there would be an excess of iodide ions, so the reaction would shift toward the left, causing more silver iodide to precipitate out of solution.

Common ion effect

Calculate the molar solubility of cadmium sulfide (CdS) in a 0.010- M solution of cadmium bromide (CdBr 2 ). The K sp of CdS is 1.0 × 10 –28 .

Solution

The first thing you should notice is that the cadmium sulfide is dissolved in a solution that contains cadmium ions. We need to use an ICE table to set up this problem and include the CdBr 2 concentration as a contributor of cadmium ions:

CdS ( s ) Cd 2+ ( a q ) + S 2− ( a q )
This table has two main columns and four rows. The first row for the first column does not have a heading and then has the following in the first column: Initial concentration ( M ), Change ( M ), and Equilibrium concentration ( M ). The second column has the header, “C d S equilibrium arrow C d to the second power plus S to the second power superscript negative sign.” Under the second column is a subgroup of three rows and three columns. The first column is blank. The second column has the following: 0.010, x, 0.010 plus x. The third column has the following: 0, x, 0 plus x equals x.
K sp = [ Cd 2+ ] [ S 2− ] = 1.0 × 10 28
( 0.010 + x ) ( x ) = 1.0 × 10 28
x 2 + 0.010 x 1.0 × 10 28 = 0

We can solve this equation using the quadratic formula, but we can also make an assumption to make this calculation much simpler. Since the K sp value is so small compared with the cadmium concentration, we can assume that the change between the initial concentration and the equilibrium concentration is negligible, so that 0.010 + x ~ 0.010. Going back to our K sp expression, we would now get:

K sp = [ Cd 2+ ] [ S 2− ] = 1.0 × 10 28
( 0.010 ) ( x ) = 1.0 × 10 28
x = 1.0 × 10 26

Therefore, the molar solubility of CdS in this solution is 1.0 × 10 –26 M .

Check your learning

Calculate the molar solubility of aluminum hydroxide, Al(OH) 3 , in a 0.015- M solution of aluminum nitrate, Al(NO 3 ) 3 . The K sp of Al(OH) 3 is 2 × 10 –32 .

Answer:

1 × 10 –10 M

Got questions? Get instant answers now!

Questions & Answers

how do you get the 2/50
Abba Reply
number of sport play by 50 student construct discrete data
Aminu Reply
width of the frangebany leaves on how to write a introduction
Theresa Reply
Solve the mean of variance
Veronica Reply
Step 1: Find the mean. To find the mean, add up all the scores, then divide them by the number of scores. ... Step 2: Find each score's deviation from the mean. ... Step 3: Square each deviation from the mean. ... Step 4: Find the sum of squares. ... Step 5: Divide the sum of squares by n – 1 or N.
kenneth
what is error
Yakuba Reply
Is mistake done to something
Vutshila
Hy
anas
hy
What is the life teble
anas
hy
Jibrin
statistics is the analyzing of data
Tajudeen Reply
what is statics?
Zelalem Reply
how do you calculate mean
Gloria Reply
diveving the sum if all values
Shaynaynay
let A1,A2 and A3 events be independent,show that (A1)^c, (A2)^c and (A3)^c are independent?
Fisaye Reply
what is statistics
Akhisani Reply
data collected all over the world
Shaynaynay
construct a less than and more than table
Imad Reply
The sample of 16 students is taken. The average age in the sample was 22 years with astandard deviation of 6 years. Construct a 95% confidence interval for the age of the population.
Aschalew Reply
Bhartdarshan' is an internet-based travel agency wherein customer can see videos of the cities they plant to visit. The number of hits daily is a normally distributed random variable with a mean of 10,000 and a standard deviation of 2,400 a. what is the probability of getting more than 12,000 hits? b. what is the probability of getting fewer than 9,000 hits?
Akshay Reply
Bhartdarshan'is an internet-based travel agency wherein customer can see videos of the cities they plan to visit. The number of hits daily is a normally distributed random variable with a mean of 10,000 and a standard deviation of 2,400. a. What is the probability of getting more than 12,000 hits
Akshay
1
Bright
Sorry i want to learn more about this question
Bright
Someone help
Bright
a= 0.20233 b=0.3384
Sufiyan
a
Shaynaynay
How do I interpret level of significance?
Mohd Reply
It depends on your business problem or in Machine Learning you could use ROC- AUC cruve to decide the threshold value
Shivam
how skewness and kurtosis are used in statistics
Owen Reply
yes what is it
Taneeya
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 4

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Chemistry. OpenStax CNX. May 20, 2015 Download for free at http://legacy.cnx.org/content/col11760/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Chemistry' conversation and receive update notifications?

Ask